Avaya 03-300430 Manuel D’Utilisation
Communication Manager Maintenance-Object Repair Procedures
2500 Maintenance Procedures for Avaya Communication Manager 3.0, Media Gateways and Servers
2012
ABRT
Could not allocate the necessary system resources to run test.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the problem persists, escalate the problem.
2100
ABRT
Internal system error.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the problem persists, escalate the problem.
1
FAIL
The buffer level is nearly exhausted.
2
FAIL
The VAL is congested, and no buffers are available.
1. Retry command at 1-minute intervals up to 5 times.
2. If command continues to fail, examine the VAL port measurements to
determine which ports are heavily utilized and the processor
occupancy of the circuit pack.
occupancy of the circuit pack.
A Low processor occupancy when VAL is congested indicates circuit pack
failure.
failure.
1. If the problem persists, reset the circuit pack (reset board
location).
2. If congestion recurs, replace the circuit pack.
High processor occupancy indicates the VAL is congested due to traffic
load.
●
To relieve congestion in the short term, selectively busyout ports
(busyout port location) on the VAL circuit pack.
(busyout port location) on the VAL circuit pack.
●
To achieve a more permanent resolution, it could be necessary
reassign announcements to other integrated announcement circuit
packs.
reassign announcements to other integrated announcement circuit
packs.
Consider replacing affected VAL ports with new ports.
3
FAIL
The VAL circuit pack is not operating normally and is congested.
PASS
Hardware setting and attached cable type match VAL circuit pack
administration. The circuit pack detects no errors.
Table 886: Test #600 Congestion Query Test (continued)
Error
Code
Code
Test
Result
Result
Description / Recommendation
2 of 2