Bosch DVA-16K Manuel D’Utilisation

RAID Subsystem DVA-16K | Installation Manual

Hardware Installation | en 21 

Bosch Security System

F.01U.027.799 | V2 | 2008.08

Following all the instructions provided below can save subsystem installation time. Detailed, 

illustrated instructions for each component are given in the following sections.

1.

Unpack: Unpack the subsystem and confirm that all the components on the packing list 

have been included. (See Section 3.5 Unpacking the Subsystem)

2.

Rack/Cabinet installation: If the subsystem is going to be installed in a rack or cabinet, it 

should be installed prior to installing the hard drives. Installing the subsystem into a rack 

or cabinet requires at least two (2) people. (See Section 3.6 Rack/Cabinet Installation)

3.

Install drive trays: After the hard drives have been installed into the drive trays, the drive 

trays must be installed into the enclosure itself. (See Section 3.7 Drive Tray Installation)

4.

Cable connection: Use the power cables to connect the subsystem to the main power 

source. Use the SCSI cable to connect a host port to the host computer or an external 

device.

5.

Power up: Once the components have been properly installed and all cables are properly 

connected, you can power up the subsystem and configure the RAID array. (See 

Table 3.1 shows a flowchart of the installation procedure. As you complete each step, check 

the “Done” box on the right. Please use this flowchart in conjunction with the instructions 

that follow. 

Use the Unpacking Checklist in your package to verify package contents. Carefully check the 

items contained in each box before proceeding with installation.

To ensure that your system is correctly installed, please follow the steps outlined below. If you 

follow these steps, installation will be fast and efficient. If you do not follow these steps, you 

may accidentally install the hardware incorrectly.

1

Unpack

See Section 3.5 Unpacking the Subsystem

3

Rack/Cabinet Installation

See Section 3.6 Rack/Cabinet Installation

5

Drive Tray Installation

6

Cable Connection

 

7

Power On

 See Section 5.4 Power On

Installation Procedure Flowchart

A detailed packing list can be found in your product shipping package or product CD.