PGS TC36 AR Manuel D’Utilisation

22      36ARB2 

050505-36

The Firebox Panels have to be installed for safe operation. 
Do not use the fi replace without panels. Unpack and inspect 
all panels. The panels need to be installed before the logs 
are in place.
Caution:  The Brick Panels are very fragile, and should be 
handled with care.

1)  Remove the log grate by removing the two screws retaining 

it. Screws are located behind the front legs of the grate.

2)  Remove the Side Panel Retainers located on the underside 

of the upper fi rebox heatshield. The retainers are each 
held in place by one screw.

3)  Install the Lower Rear Panel.
4)  Install the Right Side Panel by inserting the bottom of the 

panel in fi rst and then angling it up into position.

5)  Install the Left Side Panel by inserting the bottom of the 

panel in fi rst and then angling it up into position.

The rear panel is held tight against the side panels by two "V" 
brackets located on the fi rebox rear wall. Although the brackets 
are adjusted at the factory for the best fi t, some adjustment 
may be necessary. Adjust the angle of the bracket by hand 
to ensure a snug fi t.

6)  Install the Rear Upper Panel.
7)  Re-install the Side Panel Retainers.
8)  Install the Left and Right Front Panels.
9) Replace 

the 

Grate.