PGS TC36 AR Manuel D’Utilisation
24 36ARB2
050505-36
BURNER CONTROL
HI-LO Control Knob
Fig. # 33
1) HI-LO Flame Adjustment:
The HI-LO burner control knob can be rotated in both direc-
tions, providing infi nite control of gas fl ow rate to the burner
and therefore greater comfort control. The HI setting provides a
maximum gas input, and rotating the knob clockwise toward the
LO setting will reduce the gas input to a minimum setting.
The HI-LO burner control knob can be rotated in both direc-
tions, providing infi nite control of gas fl ow rate to the burner
and therefore greater comfort control. The HI setting provides a
maximum gas input, and rotating the knob clockwise toward the
LO setting will reduce the gas input to a minimum setting.
2) Wall Thermostat - Canada Only -
(Optional part # GASC.THERMO):
Set the wall thermostat to a comfortable temperature. Turn
the HI-LO burner control knob to a desired setting. As heat is
required, the fi replace will turn on or off automatically.
(Optional part # GASC.THERMO):
Set the wall thermostat to a comfortable temperature. Turn
the HI-LO burner control knob to a desired setting. As heat is
required, the fi replace will turn on or off automatically.
Extend Shutdown:
Manual Valve: To shutdown the appliance including the pilot,
partially depress and turn gas control knob clockwise past
“PILOT” to “OFF” position. DO NOT FORCE.
Manual Valve: To shutdown the appliance including the pilot,
partially depress and turn gas control knob clockwise past
“PILOT” to “OFF” position. DO NOT FORCE.
NOTE: The SIT control has an interlock device which does
not allow the pilot to be lit when the appliance is at operating
temperature. Let the appliance cool down (approx. 60 sec.)
before attempting to relight the pilot. DO NOT use force to
rotate the control knob.
not allow the pilot to be lit when the appliance is at operating
temperature. Let the appliance cool down (approx. 60 sec.)
before attempting to relight the pilot. DO NOT use force to
rotate the control knob.
Electronic Valve: Push the "Burner" switch to the "Off" posi-
tion. Turn off all electric power to the appliance and remove
backup batteries if service is to be performed or for extended
shutdown.
tion. Turn off all electric power to the appliance and remove
backup batteries if service is to be performed or for extended
shutdown.
LIGHTING INSTRUCTIONS
1. STOP! Read the safety information above on this label.
2. Set wall thermostat to lowest setting, if applicable.
3. This appliance is equipped with an ignition device which
2. Set wall thermostat to lowest setting, if applicable.
3. This appliance is equipped with an ignition device which
automatically lights the pilot. Do not try to light the pilot by
hand.
hand.
4. Push the "Burner" switch to the "Off" position.
5. Allow
5. Allow
suffi cient length of time (minimum 5 minutes) for any
gas in the combustion chamber to escape. If you still smell
gas, STOP! Follow "B" in the safety information above on
this label. If you don't smell gas, go to the next step.
gas, STOP! Follow "B" in the safety information above on
this label. If you don't smell gas, go to the next step.
WARNING: If you do not follow these instructions
exactly, a fi re or explosion may result causing
property damage, personal injury or loss of life.
property damage, personal injury or loss of life.
A. This appliance is equipped with an ignition device which auto-
matically lights the pilot. Do not try to light the pilot by hand.
B. BEFORE LIGHTING smell all around the appliance area for gas.
Be sure to smell next to the fl oor because some gas is heavier
than air and will settle on the fl oor.
than air and will settle on the fl oor.
WHAT TO DO IF YOU SMELL GAS:
- Do not try to light any appliance.
- Do not touch any electric switch; do not use any phone in your
FOR YOUR SAFETY READ BEFORE LIGHTING
6. Push the "Burner" switch back to the "On" position.
- If the burner does not light, repeat steps 4 through 6.
- If the burner will not light or stay lit after several tries,
turn the "Burner" switch to the "Off" position and call your
service technician or gas supplier.
turn the "Burner" switch to the "Off" position and call your
service technician or gas supplier.
Note:
Suffi cient time must be allowed for air to escape from
lines if the unit is being lit for the fi rst time.
7. Turn HI-LO burner control knob to desired setting and close
control door.
8. Set thermostat to desired setting, if applicable.
building.
- Immediately call your gas supplier from a neighbour's phone.
Follow the gas supplier's instructions.
Follow the gas supplier's instructions.
- If you cannot reach your gas supplier, call the fi re depart-
ment.
ment.
C. Use only your hand to push in or turn the gas control knob.
Never use tools. If the knob will not push in or turn by hand,
don't try to repair it, call a qualifi ed service technician. Force or
attempted repair may result in a fi re or explosion.
don't try to repair it, call a qualifi ed service technician. Force or
attempted repair may result in a fi re or explosion.
D. Do not use this appliance if any part has been under water.
Immediately call a qualifi ed service technician to inspect the
appliance & to replace any part of the control system & any gas
control which has been under water.
appliance & to replace any part of the control system & any gas
control which has been under water.
TO TURN OFF GAS TO APPLIANCE
1. Set wall thermostat to lowest setting, if applicable.
2. Push the "burner" switch to the "Off" position.
2. Push the "burner" switch to the "Off" position.
3. Turn off all electric power to the appliance and remove
backup batteries if service is to be performed or for extended
shutdown.
shutdown.
Due to high surface temperatures, keep children, clothing and furniture away. Keep burner and control compartment clean. See
installation and operating instructions accompanying the appliance.
installation and operating instructions accompanying the appliance.
A cause de la temperature elevee des parios, tenir eloignes les enfants, les vetements et les meubles. Maintenir propres le
bruleur et le compartiment de commande. Voir les instructions relatives a l'installation et au fonctionnement qui accompagnent
l'appareil.
bruleur et le compartiment de commande. Voir les instructions relatives a l'installation et au fonctionnement qui accompagnent
l'appareil.
LIGHTING INSTRUCTIONS - Electronic Valve