Empire Comfort Systems LS-30B2-1 Manuel D’Utilisation

Page 5

21088-2-0706

Before you begin: Do not, handle these logs with your bare hands! 

Always wear gloves to prevent skin irritation. After handling logs, 

wash your hands gently with soap and water.
All Logs

The  positioning  of  the  logs  is  critical  to  the  safe  and  clean 

operation of this heater. Sooting and other problems may result if 

the logs are not properly and firmly positioned in the appliance.
Refer to Figure 1 and Figure 1A for the following warning.

Warning: Failure to position the parts in accordance with 

this diagram or failure to use only parts specifically approved 

with this appliance may result in property damage or personal 

injury.

(Figure 1)  

  1. Place rear (#1) log onto two (2) pins on rear log support.

  2. Place left, front (#2) log onto two (2) left, front pins on burner 

pan.

  3. Place right, front (#3) log onto two (2) right, front pins on 

burner pan.

  4. Place Y Branch (#4) onto two (2) pins on rear log.

  5. Compare the completed log installation with the appropriate 

photo from pages 7 through 9. Review previous steps to make 

any necessary adjustments.

  6. Log placement is completed.

Note: A  single  layer  of  embers  is  to  be  used  when  applying 

Platinum Bright Embers (alone or in combination with production 

embers) to the burner.

The following WARNING applies when log set is installed onto 

an unvented gas burner assembly.

1

2

3

4

LS-18B

15999

LS-24B

15970

LS-30B

15970

Platinum Bright Embers

PE-20-1