Manualsbrain.com
  1. Manuels
  2. Marques
  3. Empire Comfort Systems
  4. SR-30
  5. Manuel D’Utilisation

Empire Comfort Systems SR-30 Manuel D’Utilisation

Télécharger
Page de 24
16942-5-0907
Page 10
When facing the front of the appliance the following 
minimum clearances to combustible construction must be 
maintained.
Left side 8 inches (203mm). Right side 8 inches 
(203mm).
Do not install in alcove or closet.
Rear wall 0 inches (0mm). Ceiling 36 inches (914mm).
Minimum vertical clearance from a projection above 
the appliance (shelves, window sills, etc.) 36 inches 
(914mm).
Floor (top surface of carpeting, tile, etc.) 2 inches 
(51mm).
Provide adequate clearances around air openings.
Adequate accessibility clearances for purposes of servicing 
and proper operation must be provided.
Refer to Figures 9, 10, 11 and 12 for measurements in order to locate (4) mounting holes on wall. Figures 9, 10, 11 and 12 are the front 
views of the heaters.
1. Remove lower louver from casing assembly (2 screws).
2. Remove reflector from casing assembly (2 screws).
3. Remove upper louver from casing assembly (2 screws).
CEILING
SIDE WALL
8” MIN.
8” MIN.
36” MIN
2” MIN
FLOOR
Figure 8 (SR-30)
Figure 9 (SR-6)
Figure 10 (SR-10)
MOUNTING HOLE LOCATIONS
VIEWED FROM FRONT OF HEATER
FLOOR
4 1/32”
(102mm)
2” MIN (51mm)
18 7/8”
(479mm)
22”
(559mm)
OUTLINE OF
OUTER CASING
1 3/32”
(28mm)
2”
(51mm)
2”
(51mm)
7 13/16”
(198mm)
11 13/16”
(300mm)
11 13/16”
(300mm)
7 13/16”
(198mm)
2”
(51mm)
2”
(51mm)
1 3/32”
(28mm)
18 7/8”
(479mm)
OUTLINE OF
OUTER CASING
22”
(559mm)
FLOOR
4 1/32” MIN
(102mm)
2” MIN (51mm)
MOUNTING HOLE LOCATIONS
VIEWED FROM FRONT OF HEATER
SR-30 CLEARANCES
WALL MOUNT INSTALLATION