Dimplex SS5800PB Manuel D’Utilisation

7

A 15amp, 120 volt 

alternating current (VAC) circuit 

is required.  A dedicated circuit is 

preferred but not essential in all 

cases.  A dedicated circuit will be 

required if, after installation, the 

circuit breaker trips or fuse blows 

on a regular basis when the 

heater is operating.  Additional 

appliances on the same circuit 

may exceed the current rating of 

the circuit breaker.

 WARNINg: Ensure the power 

cord is not installed so that it is 

pinched or against a sharp edge 

and ensure that the power cord 

is stored or secured to avoid 

tripping or snagging to reduce the 

risk of fire, electric shock or injury 

to persons.

  WARNINg:Construction 

and electrical outlet wiring must 

comply with local building codes 

and other applicable regulations 

to reduce the risk of fire, electric 

shock and injury to persons.

 WARNINg:Do not attempt 

to wire your own new outlets or 

circuits.  To reduce the risk of fire, 

electric shock or injury to persons, 

always use a licensed electrician.

Make sure the units Main On/

1. 

Off switch is switched Off 

(refer to operating instruction 

section).
Plug the unit directly into a 15 

2. 

Amp/120 Volt outlet.