Johnson Controls 340968-XIM-A-0108 Manuel D’Utilisation

340968-XIM-A-0108

4

Johnson Controls Unitary Products

These units must be installed in accordance with the follow-
ing national and local safety codes.

1.

National Electrical Code ANSI/NFPS No. 70 or Canadian 
Electrical Code Part 1, C22.1 (latest editions).

2.

National Fuel Gas Code Z223.1 or CAN/CGA B149.1 
or.2 Installation Code.

3.

Local gas utility requirements.

4.

Local plumbing and waste water codes and other appli-
cable local codes.

Refer to Table 1 for unit application data and to Table 2 for
gas heat application data.

If components are to be added to a unit to meet local codes,
they are to be installed at the dealer's and/or the customer's
expense.

Size of unit for proposed installation should be based on heat
loss/heat gain calculations made in accordance with industry
recognized procedures identified by the Air Conditioning
Contractors of America.

Use the following guidelines to select a suitable location for
these units.

1.

Unit is designed for outdoor installation only.

2.

Condenser must have an unlimited supply of air. Where 
a choice of location is possible, position unit on either 
north or east side of building.

3.

For ground level installation, a level pad or slab should 
be used. The thickness and size of the pad or slab used 
should meet local codes and unit weight. Do not tie the 
slab to the building foundation.

4.

For roof top installation, be sure the structure will support 
the weight of the unit plus any field installed components. 
Unit must be installed on a level roof curb or appropriate 
angle iron frame providing adequate support under the 
compressor/condenser section.

5.

Maintain level tolerance of unit to 1/8" maximum.

Care must be exercised when moving the unit. Do not
remove any packaging until the unit is near the place of
installation. Rig unit with slings placed under the unit.
Spreader bars of sufficient length should be used across the

top of the unit.

Units may also be moved or lifted with a fork-lift. Slotted
openings in the skid are provided for this purpose. Forks
must pass completely through the base.

Refer to Table 2 for unit weights and to Figure 2 for approxi-
mate center of gravity.

Voltage Variation

Min. / Max.

1

1.

Rated in accordance with ARI Standard 110, utilization range 
“A”.

208/230V

2

2.

“T1” transformer primary tap must be moved from the 230 volt 
connection to the 208 volt connection for low voltage applica-
tions of 208 volt and below

187 / 253

Wet Bulb Temperature (°F) of Air on

Evaporator Coil,  Min. / Max.

57 / 72

Dry Bulb Temperature (°F) of Air on

Condenser Coil, Min.

3

 / Max.

3.

A low ambient accessory is available for operation down to 0 °F.

45 / 120

Excessive exposure of this furnace to contami-
nated combustion air may result in equipment 
damage or personal injury. Typical contaminants 
include: permanent wave solution, chlorinated 
wastes and cleaners, chlorine based swimming 
pool chemicals, water softening chemicals, carbon 
tetrachloride, halogen type refrigerants, cleaning 
solvents (e.g. perchloroethylene), printing inks, 
paint removers, varnishes, hydrochloric acid, 
cements and glues, antistatic fabric softeners for 
clothes dryers, masonry acid washing materials.

Before lifting a unit, make sure that its weight is dis-
tributed equally on the cables so that it will lift 
evenly.