Quadra-Fire CB1200-B Manuel D’Utilisation

R 

R 

R 

September 1, 2008

7014-082D

Page  27

Convection blower fails to 

start.

#1 snap disc defective.

Blower not plugged in.

Blower is defective.

Control box is defective.

Replace snap disc.

Check that blower is plugged into wire har-

ness.

Replace blower.

Replace control box.

Exhaust blower fails to 

start or does not shut off.

Blower not plugged in.

Blower is clogged with ash.

Blower is defective.

Control box is defective.

Check that blower is plugged into wire har-

ness.

Clean exhaust system.

Replace blower.

Replace control box.

Large, lazy flame, orange 

color.  Black ash on glass.

Dirty appliance.

Poor fuel quality, high ash content.

Firepot clean-out plate not completely 

closed.

Excessive amount of fuel.

Clean unit, including firepot, heat exchang-

ers and venting system.  Remove stainless 

steel baffle from firebox to clean ash from 

on top of baffle.  Clean behind rear brick 

panels.  Change fuel brand to premium.

Check that firepot clean-out plate is fully 

closed.

Reduce feed rate using feed rate adjustment 

control rod located inside hopper.

Nuisance shutdowns.

Low flame.

Sawdust buildup in hopper.

Feed motor is reversing.

Defective thermocouple.

Defective control box.

Firepot more than 1/2 full.

Increase feed by opening feed rate adjust-

ment control rod located inside hopper.

Clean hopper, see 

Check for good connections between feed 

motor and wire harness.

Replace thermocouple.

Replace control box.

See 

page 31 for detailed instructions for 

“High Ash Fuel Content Management”

Appliance calls for heat.

Call light illuminates.

Exhaust blower starts.

No feed or igniter.

Thermocouple is defective or not properly 

plugged in.

Defective control box

Check connections on thermocouple or 

replace if defective.

A flashing yellow light on the control box 

indicates a problem with the thermocouple.

Replace control box.