Quadra-Fire CB1200-B Manuel D’Utilisation

Page 6

7014-082D

September 1, 2008

CB 1200 Pellet Stove

16. Snap Disc #1 (Convection Blower) 145°F
Snap disc #1 is located on the right side of the appliance on

the top of the heat exchanger box. There are 2 purple wires

connected to it. This snap disc turns the convection blower

on and off as needed. Power is always present at snap disc

#1.
17. Snap Disc #2 (Thermostat Override) 200°F
Snap disc #2 is also located on the right side of the appliance

between snap disc #1 and convection blower. There are 2

yellow wires connected to it. This snap disc will turn off the

feed system, which will turn off the appliance if an overfire

condition should occur or if the convection blower should fail

to operate.
18. Snap Disc #3 (Back Burn Protector) 250°F
Snap disc # is mounted on the back of the auger tube in the

right side of the appliance just below the feed motor and has

a red reset button. To access it remove the feed motor cover

box from inside the hopper. If the fire tries to burn back

into the feed system or push exhaust up the feed tube, this

snap disc will shut the entire system off. This disc must be

manually reset.
19. Vacuum Switch
The vacuum switch is located on the left side of the appliance

behind the inner shield. This switch turns the feed system on

when vacuum is present in the firebox. The vacuum switch

is a safety device to shut off the feed motor if the exhaust

or the heat exchanger system is dirty or plugged or if the

firebox door is open.
20. Wiring Harness
See Figure 36.1 below.

Figure 36.1

Thermocouple

Heat

Output

Switch

Thermostat

Block

Snap

Disc #2

Snap

Disc #1

Feed

Motor

Male

Vacuum

Switch

Capacitor

Female

Convection

Blower

Speed

Exhaust

Blower

Snap

Disc #

Reset

Button

Call Light

Fuse

Yellow

Purple

Red

Orange

White

Yello

Blue

Black

Gray

High Temp

Yello

Igniter