Quadra-Fire CB1200-B Manuel D’Utilisation

Page  4

7014-082D

September 1, 2008

R 

R 

R 

•  Glass is 5mm thick high temperature heat-

resistant ceramic glass.

•  DO NOT REPLACE with any other material.
•  Alternate material may shatter and cause 

injury.

Top & Bottom Frame

Door Latch

Side

Frame

Center Posts

Glass

Remove Door Latch First

and then Side Frame

Door Frame

shown with no

Glass or Glass

Frames

Remove 5 nuts from Bottom Frame

Handle glass with care.

•  Inspect the gasket to ensure it is 

undamaged.

•  Do NOT strike, slam or scratch glass.

•  Do NOT operate appliance with glass  

assembly removed. 

•  Do NOT operate with glass cracked, broken or scratched.

 

•  Remove door from appliance and place face down 

on a protected surface to avoid scratching the door.

 

•  Remove all door rope.

NOTE:  DO NOT LET Air Wash Spacers fall down from 

  a.  Be sure the appliance is allowed to cool, has been 

unplugged and the exhaust blower is off.

  b.  Using  a  nut  driver  remove  the  (5)  bottom  nuts  and 

remove the bottom glass frame. 

  c.  Slightly bend up and out of the way the 2 center posts 

and slide the glass out the bottom.

  d.  Slide new glass in, reposition the 2 center posts and 

re-install bottom glass frame.

  e.  Re-rope the door.

  a.  Be sure the appliance is allowed to cool, has been 

unplugged and the exhaust blower is off.

  b.  Remove side glass frame.
  c.  Loosen the top and bottom frame and slightly bend 

up and out of the way.

  d.  Slide glass out the side and slide new glass in.
  e.  Re-install the side glass frame and tighten the top 

and bottom frames.

  f.  Re-install the door latch, if applicable, and re-rope 

the door.