Regency C33-LP2 Manuel D’Utilisation
Regency CLASSIC C33-2 Freestanding Gas Stove
17
7) Install the replacement glass. When placing
the replacement glass in the door, make
sure that the glass gasketing will properly
seal your unit.
sure that the glass gasketing will properly
seal your unit.
8) Put glass in place and then position glass
retainer rod.
Note: Do not use substitute materials. If
your glass does break, do not
continue to use your unit until it
has been replaced.
continue to use your unit until it
has been replaced.
9) Position the glass retainer clips and door
securing bracket. Secure the glass retain-
ing screws but do not overtighten as this
may cause the glass to break after the unit
heats up.
ing screws but do not overtighten as this
may cause the glass to break after the unit
heats up.
10) Tighten all screws evenly.
Note: Do not overtighten as this may
cause breakage.
11) Slip door over hinge pins.
12) Put hinge caps back onto door.
13) Close door and secure the security bracket
with the screw.
GLASS
REPLACEMENT
Your CLASSIC stove is supplied with high
temperature, 5 mm Neoceram ceramic glass
that will withstand the highest heat that your
unit will produce. In the event that you break
your glass by impact, purchase your replace-
ment glass from an authorized Regency dealer
only, and follow our step-by-step instructions
for replacement.
temperature, 5 mm Neoceram ceramic glass
that will withstand the highest heat that your
unit will produce. In the event that you break
your glass by impact, purchase your replace-
ment glass from an authorized Regency dealer
only, and follow our step-by-step instructions
for replacement.
1) Allow the stove to cool before removing or
replacing glass.
2) To remove the door from the stove remove
the securing screw located between the
ashlip and the door, then unfasten the latch.
ashlip and the door, then unfasten the latch.
3) Remove gold hinge caps from door.
4) Lift door off hinge.
5) Lay door on a soft, flat surface.
6) Remove the screws in the glass retainer
clips and remove the glass retainer rod.
Remove any remaining pieces of glass and
ensure that the door is free of debris. Use
caution when removing broken glass to
avoid injury.
Remove any remaining pieces of glass and
ensure that the door is free of debris. Use
caution when removing broken glass to
avoid injury.
MAINTENANCE
LOG REPLACEMENT
The unit should never be used with broken
logs. Turn off the gas valve and allow the unit
to cool before opening door to carefully re-
move the logs. The pilot light generates enough
heat to burn someone.
logs. Turn off the gas valve and allow the unit
to cool before opening door to carefully re-
move the logs. The pilot light generates enough
heat to burn someone.
If for any reason a log should need replace-
ment, use only Regency replacement logs. The
position of these logs must be as shown in the
diagram under Log Installation.
ment, use only Regency replacement logs. The
position of these logs must be as shown in the
diagram under Log Installation.
NOTE: Improper positioning of logs may
create carbon build-up and will
alter the unit’s performance
which is not covered under war-
ranty.
alter the unit’s performance
which is not covered under war-
ranty.
GOLD-PLATED DOORS
The 24 carat gold plated finish on the door
requires little maintenance, and need only be
cleaned with a damp cloth. DO NOT use
abrasive materials or chemical cleaners, as
they may harm the finish and void the warran-
ty. Clean any fingerprints off before
turning the unit on.
requires little maintenance, and need only be
cleaned with a damp cloth. DO NOT use
abrasive materials or chemical cleaners, as
they may harm the finish and void the warran-
ty. Clean any fingerprints off before
turning the unit on.