Regency C33-LP2 Manuel D’Utilisation

16

Regency CLASSIC C33-2 Freestanding Gas Stove

Conduct an inspection of the venting system at
least annually. Recommended areas to inspect
are:

1) Check areas of the Venting System which

are exposed to the elements for corrosion.
These will appear as rust spots or streaks,
and in extreme cases, holes. These com-
ponents should be replaced immediately.

2) Remove the Cap, and shine a flashlight

down the Vent. Remove any birds nests, or
other foreign material.

3) Check for evidence of excessive conden-

sation, such as water droplets forming in
the liner, and subsequently dripping out the
joints, Continuous condensation can cause
corrosion of caps, pipe, and fittings. It may
be caused by having excessive lateral
runs, too many elbows, or exterior portions
of the system being exposed to cold weath-
er.

4) Inspect joints, to verify that no pipe sections

or fittings have been disturbed, and conse-
quently loosened. Also check mechanical
supports such as Wall Straps for rigidity.

1) Loosen the thermocouple or thermopile

with a 7/16" wrench at bracket.

2) Disconnect thermocouple by loosening nut

from the valve with a 9mm wrench. Discon-
nect thermopile by loosening 2 screws
marked TP on the valve.

3) Drop the thermocouple or thermopile down

from the bracket and pull it out of the unit.

4) Reinstall the new ones in reverse order.

The aeration adjustment rod is attached to the
air shutter on the burner. The air shutter adjust-
ment rod is located under the ashlip on the right
side. The rod is used to adjust the aeration on
the burner. This adjustment is performed by the
installer and is primarily used in installations at
high elevations. Push the rod in for a yellow
flame, or pull out on the rod for a bluer flame.

Air shutter opening:

Natural Gas 7/16"
Propane

Wide open