Regency C33-LP2 Manuel D’Utilisation

Regency CLASSIC C33-2 Freestanding Gas Stove

7

9) Lift the fan assembly in through the pedes-

tal and up through the cut out as shown in
diagrams 3 and 4.

10) Put the insulation gasket on the back of the

fan. Line up the keyhole slots with the
matching screws and pull back slightly to
lock into place. While holding fan assembly
in place, tighten screws.

For pedestal unit: To install the fan in an

installed stove-access from front through
the pedestal by following the directions
below. If the stove is not installed - access
through rear and follow steps 4 to 17.

The clearances listed below are MINIMUM dis-
tances.  Measure the clearance to both the
appliance and the chimney connector. The
farthest distance is correct if the two clearanc-
es do not coincide. For example, if the appliance
is set as indicated in one of the diagrams but the
back wall is too close, move the stove until the
correct clearance to the back wall is obtained.

This unit can be installed on a solid combustible
surface like a wood floor. This unit can also be
installed directly on carpeting or vinyl when the
bottom pedestal cover plate (provided with the
unit) is installed.

This appliance may be installed only with the
clearances as shown in the situations pic-
tured.  Do not combine clearances from one
type of installation with another in order to
achieve closer clearances. Use the minimum
clearances shown in the diagrams. Alcove
installations are approved, as long as side wall
clearances are maintained.

A

Side Wall to Unit

10" / 250 mm

B

Back Wall to Unit

6" / 150 mm

E

Side Wall to Unit

1.5" / 38 mm

to Flue Centerline

C

Back Wall

11-1/2"/ 292 mm

D

Side Wall

22" / 559 mm

F

Side Wall

13" / 330 mm

2) If required, adjusting the primary air to

ensure that the flame does not carbon. First
allow the unit to burn for 15-20 min. to
stabilize.

3) Check for proper draft.

For leg unit: remove 7 screws,  remove

bottom access panel and install fan as-
sembly and follow steps 4 to 17.

1) Open pedestal door and remove door cov-

er plate by removing 4 screws. See dia-
gram 1.

2) Remove valve cover plate by removing 2

screws.

3) Remove wire from piezo ignitor.

4) Screw the four 8-32 x 3/4 screws provided

into the nutserts as shown in diagram 3. Do
not tighten screws.

5) Push all the fan wires through the hole on

the fan assembly. See diagram 2

.
6) Put power cord (shown in diagram 3)

through the hole and pull through to front of
unit for easier installation of ground wire.

7) Place fan assembly partially in door cover

plate hole. See diagram 2.

8) Attach the 2 ground wires (green) to the

ground lug as per diagram 2.

Note:

Ground lug is located on the bottom

of the fan assembly. See diagram 2.