Regency C33-LP2 Manuel D’Utilisation

8

Regency CLASSIC C33-2 Freestanding Gas Stove

1) For easier assembly, tip the stove on its

back (preferably onto a soft surface to
prevent scratching).

2) Unscrew the 4 bolts in the underside of the

stove. Align the holes in the corners of the
pedestal top with the corresponding holes
in the base of the stove.  Use washers
which are supplied with the pedestal as
shown in diagram. Reinstall bolts.

11) Remove the dummy plug from the right side

of the bottom shield or pedestal and install
the supplied fan switch.

12) Attach hot wire from power cord to the

thermodisc.

13) Slide the thermodisc under the bracket.

16) Pull power wire back and put strain relief

grommet in place as per diagram 4.

17) Reverse steps 3-1 to complete installation.

 Note: The #8 ground lug is a dedicated
ground for mobile home use only.

Only C34 unit is approved for mobile homes.

1) Disconnect the power to fan.

2) Allow the stove to cool to room tempera-

ture.

3) Open the pedestal door  and remove the

screws on the door cover plate. Leg Units:
Remove bottom access panel.

4) Loosen the nutsert screws.

5) Remove Fan Assembly from the key slots

at the fan base. Take the fan out from the
rectangular opening . Diagram 3.

6) Turn the fan around 90 degrees (Pedestal

units only). Diagram 2.

7) Disconnect the green ground wires to the

grounding lug.

8) Disconnect the white wire of the fan from

the power cord.

9) Disconnect red wire and black wire (from

fan to Fan Switch).

10) Take fan out from the stove body. Diagram

1.

14) Connecting wires to the 3 way switch -

a.  Connect the red wire from the fan to the
top of the 3 way switch.
b. Connect black wire from fan to the bottom
of the 3 way switch.
c. Connect white jumper wire to middle of
the three way switch. See wiring diagram
below.

15) Connect white wire from fan motor to neu-

tral on the power cord.

3) Hook up wires to Burner ON/OFF switch

and valve assembly (be careful not to pinch
wires). See Diagram 1.

4) Push the Regency logo into the two holes

in the front bottom left corner of the pedestal
cover plate.