Frigidaire DGGF3032KB Manuel Du Propriétaire

30

properly in place.
To  avoid  possible  burns  DO  NOT  attempt  any  of  the 

following  cleaning  instructions  provided  before  turning 

OFF all of the surface burners and allow them to cool.

● For proper gas flow and ignition of the burners — DO 

NOT allow spills, food, cleaning agents or any other 

material to enter the gas orifice opening.

● The cooktop is not removable. Do not attempt to 

remove or lift the cooktop.

When placing the burner caps on the cooktop, be sure 

the burner caps are seated firmly on top of burner heads. 

Improper flame size and uneven heating may result when 

any surface burners are turned ON and the burner caps 

are not seated correctly.

The cooktop is designed to make cleaning easier. Because 

the gas Burners are sealed, cleanups are easy when 

spillovers are cleaned up immediately. 
The cooktop, Burner Heads and Caps should be routinely 

cleaned. Keeping the Burner Head Ports clean will 

prevent improper ignition and an uneven flame. Refer to 

the following instructions:

Figure 1- Cooktop regular burner head

Your appliance is shipped with the burner heads and 

burner caps in the correct locations. Before using your 

gas appliance be sure to:
● Follow installation instructions before operating.

● Remove all packing tape from cooktop area.

grates are cool before you place your hand, a pot 

holder, cleaning cloths or other material on them. 
The burner grates are dishwasher safe and may be 

cleaned in the dishwasher. Remove any excessive soils 

before placing in the dishwasher.

Cleaning  the  burner  caps-  Should  you  ever  need  to 

remove the burner caps for cleaning, lift the burner cap off 

the burner head. Clean heavy soils with an absorbent cloth. 

Rinse with a clean, damp cloth and immediately thoroughly 

dry including the bottom and inside of the cap. Do not use 

harsh abrasive cleaners. They can scratch the porcelain on 

the cap. Do not clean burner caps in dishwasher. 

Cleaning the burner heads- Lift the burner cap from 

the burner head. The surface burner heads are secured 

to the cooktop and must be cleaned in place (except for 

the bridge burner, which is removable. See bridge burner 

assembly section for proper installation).
For proper gas flow it may be necessary to clean the 

burner heads and slots. To clean, first use a clean DAMP 

cloth to soak up any spills. Remove any food from 

between the burner slots using a small nonabrasive brush 

like a toothbrush and afterwards wipe using a damp 

cloth. For stubborn soils located in the slots, use a small-

gauge wire or needle to clean.
Should you experience ignition problems it may be that 

an ignition port hole is partially blocked with soil (see fig 

1). With the burner head in place, use a small wire gauge 

needle or the end of a paper clip to clear the ignition port 

or ports.

cooktop- If a spill occurs on the porcelain cooktop, 

blot up spill with an absorbent cloth. Rinse with a clean, 

damp cloth and wipe dry. Do not use harsh abrasive 

cleaners on the cooktop. They can scratch the porcelain. 

Completely rinse any mild cleaners used from the surface 

or the porcelain cooktop may become damaged during 

future heating. DO NOT use spray oven cleaners on the 

cooktop.