Lightolier IS:2000LVRE1 Fascicule
INSTALLATION PROCEDURE FOR:
Lytecaster® 2000LVRE1 Low Voltage Frame- In Kit
INSTRUCTION SHEET NO.
IS:2000LVRE1
A0607
Page 2 of 2
A
COMPANY
631 Airport Road, Fall River, MA 02720
7. LAMPING (Fig. J)
1. Make sure that power is
OFF when lamping or relamping. Remove LAMP RING
from SOCKET CUP by pulling straight down.
2. Insert LAMP (MR-16 bulb) between LAMP SPRINGS until face of bulb sits
firmly on GLASS LAMP GUARD (Figure J).
3. Attach SOCKET to bi-pin prongs on LAMP.
4. Insert LAMP RING with LAMP and GLASS LAMP GUARD back into SOCKET
CUP.
NOTE: 1. LOW VOLTAGE FIXTURES should be dimmed only with special
dimmers intended specifically for that purpose. Use Lightolier Lytemode,
Scenist, Crescendo VA, Neptune VA, Precision VA, Easyset VA, Sunrise VA,
Radiant VA or equivalent products by others or variable autotransformers or
electronic dimmers intended for use with low voltage fixtures. 2. Low voltage
fixtures may produce audible sound when used with dimmers, which may be
objectional in acoustically critical areas.
Scenist, Crescendo VA, Neptune VA, Precision VA, Easyset VA, Sunrise VA,
Radiant VA or equivalent products by others or variable autotransformers or
electronic dimmers intended for use with low voltage fixtures. 2. Low voltage
fixtures may produce audible sound when used with dimmers, which may be
objectional in acoustically critical areas.
8. ADJUSTMENT (Fig. K)
1. For vertical adjustment, insert blade of screwdriver into the open slot of YOKE.
2. Using Screwdriver as a lever, tilt the entire LAMP HOLDER to the desired
angle.
3. For horizontal adjustment, rotate the LAMP HOLDER.