Honeywell 25/50ZS Manuel D’Utilisation

112

Audio Command Center Series Manual — P/N 51889:E1  6/8/2010

Programmed Activation by FACP

The FACP can be programmed to allow a specific addressable input device to generate one of five 
messages over any speaker circuit.  Any one of the five messages can be programmed to each of the 
available zones (Zone 1 through Zone 99).  In the following examples, assume that Zone 5 is pro-
grammed to Message 1, Zone 7 is programmed to Message 2, Zone 8 is programmed to Message 3, 
and Zone 35 is not programmed to a message.

•

if two devices are being programmed and the first addressable input device is programmed to 
Zone 7 and Zone 35, and a second addressable input device is programmed to Zone 5 and Zone 
35, activation of the first addressable input device (address 12 in the example below) will 
cause Message 2 to be generated over speaker circuit 3.  (Table D.5 on page 109).  If the sec-
ond addressable device (address 20 in the example below) is also activated, Message 1 will 
now be transmitted over speaker circuit 3 since Message 1 has a higher priority then Message 
2.

Programming is accomplished in the same manner as previously described.

To Program one of five messages to a speaker zone, press the ENTER key at the FACP.  The 
following screen will be displayed: 

Zone 5    and    Zone 35

Zone 7    and    Zone 35

Addressable Pull Station

(address 12)

Message 1

(highest priority of the three )

programmed to

activate

Speaker Circuit 3

Addressable Pull Station

(address 20)

programmed to

Message 2

(2nd highest priority of the three)

activate

1=READ STATUS MODE

2=PROGRAMMING MODE

3=MANUAL DIAL MODE