Honeywell 25/50ZS Manuel D’Utilisation

60

Audio Command Center Series Manual — P/N 51889:E1  6/8/2010

Installation

5. When testing is completed, remove the FC-LPS and standoff and reinstall the screw.  The 

FC-LPS is not approved for permanent connection.

The ACC-EPM External Page Module can be used to interface an existing nonemergency page sys-
tem with the ACC-25/50 Series panels.  The connection is not supervised and the external page sys-
tem will have the lowest priority which allows the ACC-25/50 Series to override all non-fire 
paging.  Paging from non-emergency equipment is prohibited during AC loss conditions to pre-
serve battery power.

The External Page Module is installed by plugging the module into connector P13 which is located 
in the top right corner of the main circuit board.

1. Carefully align the J1 connector on the ACC-EPM module with the P13 connector on the main 

circuit board and press securely into place.  Make certain the pins are properly aligned to 
prevent bending or breaking of pins.

2. Secure the ACC-EPM module to the main circuit board standoff with the supplied screw.
3. Wire the external paging system to Terminal TB1 on the ACC-EPM.  Refer to the 

documentation supplied with the external paging system to ensure proper connection.

Plug Speaker Module Cable 
into connector P2 (Step 4)

Remove mounting screw from main 
circuit board and install metal 
standoff (Steps 1 and 2)

Install FC-LPS Speaker 
Module on metal 
standoff (Step 3)

ac

2

5

sp

kr

2

.w

m

f

(Step 2) Install one metal 
standoff by screwing into place

2

55

0s

p

ks

.w

m

f

(Step 1) Remove the mounting screw 
from bottom center of main circuit board

(Step 3) Install Speaker Module 
and secure with screw

BEFORE INSTALLING ANY MODULES, MAKE CERTAIN ALL POWER (AC AND DC) HAS BEEN 
REMOVED.