Sony Ericsson DFP-D3000 Manuel D’Utilisation
9-43
DFP-3000
9.8.6 Controlling Surround EX from DTS-6 or DTS-6D
When using the DTS Co. DTS-6 or DTS-6D in the DFP-D3000 system, SA-10 operations can be con-
trolled from these cinema processors (DTS decoder) in the DFP-D3000 system.
trolled from these cinema processors (DTS decoder) in the DFP-D3000 system.
In this case, connect the control cables of the DTS-6 or DTS-6D and SA-10 as follows. In this case, the
SA-10 can be controlled regardless of the DFP-D3000 control cables.
SA-10 can be controlled regardless of the DFP-D3000 control cables.
DTS-6 “to BS22” connector
DTS-6D Automation connector
SA-10 J3, Control Input
(IDC 10-pin Connector)
(DB25 female)
(DB25 female)
Pin 6: Relay Common
Pin 13: Output common
Pin 12: GND
Pin 9: out (N.O.)
Pin 11: Logic SR
Pin 2: CTRL 1, non-decode Mode
Pin 7: IN (N.O)
Pin 25: Logic DTS
Pin 5: CTRL 4, EX decode mode
The following cables are required other than the above for the DTS-6D system.
Connect Pin 6 “Force SR
Connect Pin 6 “Force SR
+” and Pin 9 “+5V Output” of the Automation connector.
Connect Pin 19 “Force SR
_” and Pin 22 “5V GND” of the Automation connector.
9.8.7 Controlling Surround EX control from Automation Controller
When fallback using several digital formats is adopted in the DFP-D3000 system, or the SDDS signal
cannot be read, it is necessary to cancel the SA-10 Surround EX decoding operations as soon as possible.
It is also necessary to ensure compatibility for films not recorded with the Surround EX signal. By
changing the preset settings of the DFP-D3000, and preparing preset using the Surround EX not corre-
sponding to the SDDS input and preset not using the Surround EX (same as the Dolby Laboratories CP-
500), Surround EX can be controlled from an external Automation controller. The examples of preset
settings and connection methods of control cables are shown on the next page onwards. However when
using this connection method, set the Processor Select switch in the SA-10 to the CP-500 side.
DFP-D3000 Preset
DFP-D3000 Automation
SA-10, J3 Control Input
(37 pin, D-Sub, Female)
(25 pin, D-sub, Female)
Preset 1: SDDS
Pin 4: Preset 1
Pin 2: CTRL 1
Preset 2: Non-Sync
Pin 5: Preset 2
Pin 3: CTRL 2
Preset 3: Mono
(Pin 6: Ptrdry 3) No need
No need to connect
Preset 4: NR1
Pin 7: Preset 4
Pin 4: CTRL 3
Preset 5: NR2
Pin 8: Preset 5
Pin 5: CTRL 4
Preset 6: AUX 1
Pin 9: Preset 6
Pin 6: CTRL 5
Preset 7: AUX 2
Pin 10: Preset 7
Pin 7: CTRL 6
Preset 8: SDDS EX
Pin 11: Preset 8
Pin 8: CTRL 7
Pin 16: Tally Common
Pin 12: GND