Denon S-302 Manuel D’Utilisation
Set
up
up
Pla
ybac
ybac
k
Remot
Remot
e Contr
ol
Inf
or
or
mation
Tr
oubleshooting
ENGLISH
An F-type FM antenna cable plug can be connected directly.
AM/FM
Direction of broadcasting station
AM loop antenna
(Supplied)
FM antenna
75 Ω/ ohms
Coaxial cable
Coaxial cable
FM indoor antenna
(Supplied)
(Supplied)
Ground
AM outdoor antenna
Antenna Terminals
AM loop antenna assembly
Remove the vinyl tie and take out the connection
line.
line.
Connect to the AM antenna terminals.
Bend in the reverse direction.
a. With the antenna on top any stable
surface.
Mount
b. With the antenna attached to a wall.
Installation hole Mount on wall, etc.
Connection of AM antennas
1. Push the
lever.
2. Insert the
conductor.
3. Return the
lever.
NOTE
• Do not connect two FM antennas simultaneously.
• Even if an external AM antenna is used, do not disconnect the AM
• Even if an external AM antenna is used, do not disconnect the AM
loop antenna.
• Make sure the AM loop antenna lead terminals do not touch metal
parts of the panel.
External Controller
"69
065
*/
015*$"-
Extension jack for future use.
Input
Output
Infrared
retransmitter
retransmitter
Infrared
sensor
sensor
RS-232C connector
This connector is used for an external controller.
b
If you wish to control the S-302 from an external
controller using the RS-232C connector,
perform the operation below beforehand.
perform the operation below beforehand.
q
Turn the S-302’s power.
w
Turn off the S-302’s power from the external
controller.
e
Check that the S-302 is in the standby mode.
Get
ting Star
ting Star
ted
Connections
Black
White
Video
Recorder etc.
Note to CATV system installer:
This reminder is provided to call the CATV system installer’s
attention to Article 820-40 of the NEC which provides guidelines for
proper grounding and, in particular, specifies that the cable ground
shall be connected to the grounding system of the building, as
close to the point of cable entry as practical.
This reminder is provided to call the CATV system installer’s
attention to Article 820-40 of the NEC which provides guidelines for
proper grounding and, in particular, specifies that the cable ground
shall be connected to the grounding system of the building, as
close to the point of cable entry as practical.
1.S-302E3_1st.indd 18
2007/07/31 17:44:39