DTS DTS-6D Manuel D’Utilisation

REPLACING CD-ROM DRIVES

Address the TEAC drives for their location.

DTS-6D

DTS-6

Termination programmed

TEAC 16X Drive A:

Jumper 2, 4, 6

on Pin 4, that should be

Drive B:

Jumper 0, 2, 4, 6

Jumper 0, 2, 6

removed to activate.

Drive C:

Jumper 0, 1, 6

TEAC 32X Drive A:

Jumper 2

Termination programmed

Drive B:

Jumper 0, 2

Jumper 0, 2, 5

on Pin 5, that should be

Drive C:

Jumper 0, 1, 5

added to activate.

Verify the “AQRM” chip is installed in the Acqutec ROM board. The AQRM chip must be
installed correctly.

Verify the Acqutec ROM and Adaptec SCSI boards are addressed as shown on page 6.

10.

Install the Acqutec ROM and Adaptec SCSI boards. These boards must be used. See the “DTS-
6D” diagram for board orientation. It will be the same for the DTS-6 or DTS-6D. Use the saved
screw from the old SCSI board and a new #4 screw to mount both boards to player’s chassis.
NOTE: Bottom metal tab must be cut off for boards to fit correctly into unit.

11.

Connect SCSI cable to Adaptec SCSI board. Check orientation of pin 1.

12.

Apply power to player. Test the player by loading in the DTS

DS1

Setup Disc. The player should

boot-up and automatically play the disc. Be sure the

DIGITAL

and

CD-ROM

L.E.D.s

light. Check each

drive. All drives must be the same manufacturer.

13.

Re-install the top cover and re-install the player into the sound rack.