Nilfisk-Advance America IVB 5-H Manuel D’Utilisation

14

english

IVB 3-H
IVB 5-H
IVB 7-H

‡ Motor does not start

> Fuse of the mains socket has 

blown.

•

Connect mains fuse.

> Overload protection switch 

has tripped.

•

Switch off the vacuum cleaner 
and allow it to cool for approx. 
5 minutes. If the cleaner can-
not be started again, contact 
the Nilfisk-Advance service 
department.

> Self-acting carbon brush is 

worn.

•

Have carbon brushes changed 
by Nilfisk-Advance Service.

‡ Motor does not run in auto-

matic mode

> Power tool is defective or not 

connected properly.

•

Check that the power tool 
works or that the plug is inser-
ted correctly.

> The power rating of the elec-

trical tool is too low.

•

Note that minimum power ra-
ting is P>40W

‡ The acoustic warning 

sounds. (Reduced suction 
power)

> Suction power selected with 

suction power control is too 
low.

•

Set suction power in accor-
dance with section 4.2.3. „Set-
ting suction power“.

> Hose diameter is not right for 

switch position.

•

Set correct switch position for 
hose diameter.

> Clogged suction hose/nozzle.

•

Clean suction hose/nozzle

> The safety filter bag is full.

•

See  section  7.2.2  „Replacing 
filter bag“.

> Filter element is clogged.

•

See section 4.5 „Cleaning filter 
element“ and 7.2.3 „Replacing 
filter element“.

> Defective cleaning mecha-

nism

•

Contact Nilfisk-Advance Serv-
ice

‡ No suction power during 

wet cleaning

> Tank is full. (Float is blocking  

the suction opening).

•

Switch off the cleaner. Empty 
the tank.

‡ The vacuum cleaner swit-

ches off during wet clea-
ning

> Tank is full.

•

Switch  off  the  cleaner.  Empty 
the tank.

‡ Voltage fluctuations

> Impedance of power supply is 

too high.

•

Connect the cleaner to another 
socket closer to the fuse box. 
Voltage fluctuations over 7% 
should not occur if the impe-
dance at the transfer point is 
≤ 0.15 Ω .