Nilfisk-Advance America RS 1300 Manuel D’Utilisation

33015124(3)2008-02

To turn on the lighting and signalling system, use the combination switch (35, Fig. D), having the following functions:

Headlights off, with mark (35b) at the symbol O
Running lights on, with mark (35b) at the symbol 
Low beam on, with mark (35b) at the symbol 
High beam on, with mark (35b) at the symbol 

 and lowered lever (35a)

High beam temporary on, lifting the lever (35a)
Right turn signal on, bringing the lever (35a) forward
Left turn signal on, bringing the lever (35a) backward
Horn activation, pushing the lever (35a) in the direction shown by the arrow (35c)

NOTE
The suction inlet light (46, Fig. G) turns on when the running lights (2) are turned on.

Turn on the ceiling light (19, Fig. D) inside the cab by pressing on its left or right side. When the ceiling light is in central position, it 
turns off.

Turn on the 3rd broom working light with the switch (52, Fig. D).

Turn on the hazard warning lights with the switch (20, Fig. D).

To lift/lower the hopper (6, Fig. G) manually (when the diesel engine is faulty, etc.) perform the following procedure.

Check that the machine is on a solid and level ground, especially if the hopper (6, Fig. G) is full.
Turn off the engine (if it is not already off), by turning the ignition key (24, Fig. D) counterclockwise, to the end of stroke, and 
then remove it. 
Engage the parking brake (13, Fig. E).
Open the left side upper and lower lids (9 and 11, Fig. G) by disengaging the fasteners (10 and 12) with the supplied key.
Remove the hand pump lever (27, Fig. F).
Install the lever (1, Fig. O) on the hand pump (2).
Check that the hopper lifting/lowering selector (3, Fig. O) is in lifting position [try to pump with the lever (1)].
Carefully activate the pump (2, Fig. O) with the lever (1) and lift the hopper completely.
Install the lifted hopper support rods (3, Fig. F), according to the instructions shown on the relevant paragraph.

Remove the lifted hopper support rods (3, Fig. F), according to the instructions shown on the relevant paragraph.
Bring the selector (3, Fig. O) in lowering position and activate the pump (2) with the lever (1) until the hopper is completely 
lowered.
Remove the lever (1, Fig. O) from the pump and place it in its housing (27, Fig. F).
Turn the pump selector to the centre.
Close the left side upper and lower lids (11 and 9, Fig. G) by engaging the fasteners (10 and 12) with the supplied key.

1.

1.
2.

3.
4.
5.
6.
7.
8.
9.

10.
11.

12.
13.
14.