Nilfisk-Advance America 5200B Manuel D’Utilisation

12

Terra™ 5200B – 146 1996 000(2)2004-08

1.

Check the side broom height from the ground, 
proceeding as follows:
– Drive the machine on a level ground;
– Keep the machine stationary, lower the side 

brooms and rotate them for few seconds;

– Stop and lift the side brooms, then move the 

machine;

– Check that the side broom print are, in extension 

and orientation, as shown in the figure (1 and 2, 
Fig. J).
In case one or both prints are not within the 
specifications, it is necessary to adjust the broom 
height, proceeding as described in the following 
steps.

2.

Engage the parking brake by means of the pedal and 
the lever (26 and 19, Fig. B).

3.

Turn the ignition switch (18, Fig. B) to “0” position.

4.

Open the hood (13, Fig. C) and hold it by using the 
related rod (16, Fig. V).

5.

For the right side broom, actuate the driving gear of 
the lever (1, Fig. K): Loosen the ring nut (2) and adjust 
the register (3) until the correct print is achieved (1, 
Fig. J). Install the register and fit it on the lever with 
the ring nut (2, Fig. K).
For the left side broom, actuate the driving gear of 
the lever (4, Fig. K): Loosen the ring nut (5) and adjust 
the register (6) until the correct print is achieved (2, 
Fig. J). Install the register and fit it on the lever with 
the ring nut (5, Fig. K).

6.

Perform step 1 again to check the proper adjustment 
of the side broom height from the ground.

7.

When the broom is too worn out and can no longer be 
adjusted, replace it according to the instructions in the 
following paragraph.

1.

Drive the machine on a level ground and engage the 
parking brake by means of the pedal and the lever (26 
and 19, Fig. B).

2.

Turn the ignition switch (18, Fig. B) to “0” position.

3.

Operate the lever (21 or 22, Fig. B) to lower the 
related side broom.

4.

Remove the screw (1, Fig. L) inside the side broom, 
then remove the broom and the hub (2) by 
disengaging it from the shaft (3).
Recover the key (4) and the washer (5).

5.

At the workbench, remove the four screws and nuts 
(6) and separate the broom (8) from the hub (7).

6.

Install the new broom (8) on the hub (7) and tighten 
the screws and the nuts (6).

7.

Reinstall the new broom and the hub (2) on the 
machine after seating the key (4). Reinstall the 
washer (5) and tighten the screw (1).

8.

Carry out the side broom height check and 
adjustment as described in the previous paragraph.