Emerson 1700 Manuel D’Utilisation

13

To mount the transmitter/core processor assembly:

1. Identify the components shown in Figure 2-6. For dimensions, see Appendix A.

2. If desired, re-orient the transmitter on the bracket.

a.

Loosen each of the four cap screws (4 mm).

b.

Rotate the bracket so that the transmitter is oriented as desired.

c.

Tighten the cap screws, torquing to 30 to 38 in-lbs (3 to 4 N-m).

3. Attach the mounting bracket to an instrument pole or wall. For pipe mount, two user-supplied 

U-bolts are required. Contact Micro Motion to obtain a pipe-mount installation kit if required.

Mounting the remote core processor

Note: This step is required only for remote core processor with remote transmitter installations (see 
Figure 2-1). If you have an integral installation, 4-wire remote installation, or 9-wire remote 
installation, go to Section 2.6.

If you chose the remote core processor with remote transmitter installation (see Figure 2-1), see 
Figure 2-3 for a diagram of the mounting bracket supplied with the transmitter. Both pipe mounting 
and wall mounting are shown.

End-cap

Mounting bracket

Core processor housing

Transmitter

Core processor

4 × Cap screws (4 mm)

Conduit opening

for 9-wire cable