State Industries Commercial Electric Water Heater Manuel D’Utilisation

C O M M E R C I A L

SUGGESTED SPECIFICATION

The water heater(s) shall be State Patriot™ Model(s) ________, rated at _______ KW, _______ volts, _______ -phase, 60

cycle AC. Water heater(s) shall be listed by Underwriters Laboratories and meet or exceed the thermal efficiency and/or standby

loss requirements of the U.S. Department of Energy and current edition of ASHRAE/IESNA 90.1 shall be ________ gallon

capacity with a recovery capacity of ______ GPH at a temperature rise of ______°F with ______/______ upper/lower element

wattage. Heater(s) shall have 150 psi working pressure and be equipped with extruded high-density anode rod. All internal

surfaces of the heater(s) exposed to water shall be glass-lined with an alkaline borosilicate composition that has been fused to

steel by firing at a temperature of 1600°F. Electric heating elements shall be medium watt density with zinc-plated copper sheath

or Incoloy sheath _______________.

Each element shall be controlled by an individually mounted thermostat and high-temperature cutoff switch. The outer jacket

shall be a baked enamel finish and provided with a full-size control compartment for performance of service and maintenance

through a hinged front panel and shall enclose the tank with foam insulation.

Electrical junction box with heavy-duty terminal block shall be provided (except on 120V and 277V [no junction box on

PCE 6 10MSA thru PCE 20 10 MSA]). The drain valve shall be located in the front for ease of servicing. Heater tank shall

have a 3-year limited warranty as outlined in the written warranty. Fully illustrated instruction manual will be included.

For more information on State

contact:

State Water Heaters
500 Tennessee Waltz Parkway, Ashland City, TN 37015

800-365-0024 Toll-free USA

www.statewaterheaters.com
SCESS00106 August 2008R

Page 4 of 4

200694_SCESS00106.indd 4

8/14/08 12:50:24 PM