Empire Comfort Systems DVP48FP9 Manuel D’Utilisation

Page 28

17375-6-0705

WARNING: Failure to position the parts in accordance 

with this diagram or failure to use only parts 

specifically approved with this appliance may result in 

property damage or personal injury. 

Attention: Do not use Figure 48B or Figure 49 to order 

logs. Refer to parts view on page 45 and parts list on page 

46 to order logs and/or ember material for your appropriate 

fireplace model. 

LOG PLACEMENT (3 LOG SET)

Before you begin: If you are installing logs into the DVP42 

or DVP48 model then this fireplace is supplied with a set of 

three ceramic fiber logs. Do not handle these logs with your 

bare hands. Always wear gloves to prevent skin irritation 

from ceramic fibers. After handling logs, wash your hands 

gently with soap and water to remove any traces of fiber.
The positioning of logs is critical to safe and clean operation 

of this fireplace. Sooting and other problems may result if the 

logs are not properly and firmly positioned in the fireplace. 

Please refer to Figure 48A, Figure 48B, and Figure 49 and 

corresponding WARNING, when completing the following 

log placement steps.

1. Remove top louver, grasp louver, lift and pull forward.

2. Lower bottom louver, lift and hinge forward.

3. Release two glass frame spring clamps at bottom of 

firebox

4. Place bottom log onto main burner. Align holes on 

bottom log with (4) locator pins on burner.

5. Place rear log on rear log shelf. Place rear log so that the 

locator holes align with the (2) locator tabs in the log 

support shelf.

6. Place top branch onto flat area of rear log and over the 

front of the bottom log.

7.  Place decorative rock in front of grates and sides of main 

burner.

ATTENTION: Do not place decorative rock on logs or 

on burner. The decorative rock should only be placed 

on the fireplace floor.

8.  After all logs are properly positioned, place small "dime" 

size pieces of Rockwool lightly across the front round 

"blueflame" ports. Place the ember material (Rockwool 

pieces) side by side. Do not stack more than one layer of 

embers across the burner ports. See Figure 48A.

9.  Replace glass door onto firebox.
10. Secure the two glass frame spring clamps at bottom of 

firebox.

11. Align the tabs on top louver brackets with slots in front 

posts to secure top louver.

12. Close bottom louver. Lift slightly to engage the end tabs 

into the slots in fireplace sides to close louver panel.

Figure 48B

Figure 48A

Figure 49