Pfaff 350P Manuel D’Utilisation
10
Groove
(inside
holder)
(inside
holder)
6. When replacing the needle clamp, make
sure the needle bar is in its highest
position. Insert the needle clamp into
the needlebar, rotate and lightly push
upward till the pin seats into the needle
bar. Tighten the needle clamp screw
clockwise with 1.5mm Allen wrench.
position. Insert the needle clamp into
the needlebar, rotate and lightly push
upward till the pin seats into the needle
bar. Tighten the needle clamp screw
clockwise with 1.5mm Allen wrench.
Note: Replace the clear fabric cover with needle guard
and presser height adjusting screw before continuing
to use the machine.
and presser height adjusting screw before continuing
to use the machine.
Replacing the light bulb
For safety reasons, unplug main power
cord prior to replacing light bulb.
1. Make sure that the light bulb is
completely cool before removing it from
the machine.
the machine.
2. Open lamp cover.
3. Remove the light bulb and replace new
3. Remove the light bulb and replace new
one with the same type rated, MAX 15W.
Cleaning the lint box
Slide the fl atbed extension to the left to
remove it from the machine. Grasp the lint
box by the ridged fi nger grips in the front
and back and pull to the left to slide the lint
box off the machine.
remove it from the machine. Grasp the lint
box by the ridged fi nger grips in the front
and back and pull to the left to slide the lint
box off the machine.
Clean the lint out after each project.
An accumulation of lint in the box or under
the stitch plate may cause needle breakage.
the stitch plate may cause needle breakage.
Slide the lint box back into the machine.