Waves Doubler Manuel D’Utilisation

 

 

Waves Doubler software guide page 4 of 6 

:  –200 to +200 in cents. Default: 0. 

Positive values will start by modulating upwards, negative values will start off 
modulating downwards. The modulation will always occur around the voice’s 
nominal detune so if you set a detune of 10 and a Mod Depth of 10, the voice 
will begin by going upward 10 cents and then downward 20 cents, reaching 
10 cents below the nominal detune.  
 
M

: 0.1 to 200Hz. Default: 1Hz. 

This value sets the voice’s pitch modulation rate. At 1Hz the modulation will 
complete a full cycle in 1 second.   
 
 
The Direct signal controls 
  

 

 
O

: Default: On.  

Turns the voice on or off. 
 
G

: 0 to –48dBfs. Default: –12. 

Sets the gain of the voice in relation to the other voices. The master gain can 
further change the actual output gain of all voices.  
 
P

:  –45 to +45 degrees. Default: V1 22.5, V2 –22.5, V3 45, V4 –45. 

+45deg is fully right. –45deg is fully left. 0 is in the middle. In Stereo sources 
the Pan for the direct will actually behave as a Rotation control for the whole 
stereo image.  
 
EQ Controls 
 

 

 
The Doublers EQ section offers a Hi Shelf and Low Shelf filter. These filters 
will affect the Doubler’s voices, but not the direct signal. The controls for the 
filter are as follows: 
 
O

: Default: On.  

These turn the filter on and off allowing a quick A/B comparison to an EQ 
setting in relation to no EQ. Double clicking on the Graph markers will also 
turn the filter on and off.  
 
G

: +12dB to –24dB  

The Shelf can boost all that beyond its corner frequency by up to 12dB.  It can 
cut down much lower than that, down to -24dB, at which point the filter floor 
drops to make a cut filter.