ONKYO tx-sr444 Manuel D’Utilisation

Advanced Settings (Setup Menu)

Auto Input Change

On

The input of the unit will automatically be 

switched to "BLUETOOTH" when connection is 

made from a Bluetooth-enabled device to the 

unit.

"On": The input will automatically become 

"BLUETOOTH" when a Bluetooth-enabled 

device is connected.

"Off": The function is disabled.

● If the input is not switched automatically, set 

to "Off" and change the input manually.

Auto Reconnect

On

This function automatically reconnects to the 

Bluetooth-enabled device connected last when 

you change the input to "BLUETOOTH".

"On": Use this function

"Off": Do not use this function

● This may not work with some Bluetooth-

enabled devices.

Pairing Information

-

The information of the previous pairing stored in 

this unit will be initialized.

Pressing ENTER when "Clear" is displayed 

initializes the pairing information stored in this 

unit.

● This function does not initialize the pairing 

information on the Bluetooth-enabled device. 

When pairing the unit again with the device, 

be sure to clear the pairing information on 

the Bluetooth-enabled device in advance. 

For information on how to clear the pairing 

information, refer to the Bluetooth-enabled 

device's instruction manual.

Device

-

Displays the name of the Bluetooth-enabled 

device connected to the unit.

● The name is not displayed when "Status" is 

"Ready" or "Pairing".

Status

-

Displays the status of the Bluetooth-enabled 

device connected to the unit.

"Ready": Not paired

"Pairing": Pairing

"Connected": Successfully connected

Remote ID

1

Select an ID for the unit's remote controller 

from "1", "2", and "3" to prevent interference 

between the unit and other Onkyo components 

that are installed in the same room. After 

changing the ID on the main unit, change the 

ID on the remote controller accordingly with the 

following procedure.

1.  While holding down RECEIVER, press and 

hold SETUP for about 3 seconds until the 

remote indicator lights.

2.  With the number buttons, press one of 1, 2, 

and 3. The remote indicator flashes twice.