Manualsbrain.com
  1. Manuels
  2. Marques
  3. ONKYO
  4. TX-NR626
  5. Manuel D’Utilisation

ONKYO TX-NR626 Manuel D’Utilisation

Télécharger
Page de 140
Turning On & Basic Operations
En-22
When a new version of the firmware is available, the 
notification window “Firmware Update Available” 
pops up. This notification only appears when the AV 
receiver is connected to the Internet (
, 
). To perform the firmware update, follow the 
instructions on screen.
Use 
q/w and ENTER on the AV receiver or remote 
controller to select one of the options.
`
Update Now:
Starts the firmware update.
Refer to “Firmware Update” (
).
`
Remind me Later:
The update notification will pop up again the 
next time you turn the AV receiver on.
`
Never Remind me:
Disables the automatic update notification.
Tip
• The update notification window can be enabled or disabled 
in “Update Notice” (
By way of optimized circuitry, this function reduces 
power consumption when the AV receiver is in 
standby mode. The HYBRID STANDBY indicator will 
light in either of the following conditions:
–“HDMI Through” is enabled (the HDMI indicator is 
off).
–“Network Standby” is enabled (the NET indicator 
is off).
Note
• If Zones are turned on or, if a mobile device connected to 
HDMI IN 1 (MHL) is charging, the HYBRID STANDBY 
indicator won’t light.
Initial Setup 
This section explains the settings that we recommend 
you to make before using the AV receiver for the very 
first time. A setup wizard is launched upon first-time 
use to let you perform those settings.
Tip
• The on-screen menus appear only on a TV that is 
connected to HDMI OUT MAIN.
This step determines the language used for the on-
screen setup menus. See “Language” in “OSD 
Setup” (
Tip
• Pressing HOME will close the setup wizard. To restart the 
initial setup, select “Initial Setup” in the “Hardware Setup” 
menu (
After selecting the language for on-screen setup 
menus, a welcome screen is displayed.
This step performs the automatic speaker setup.
Firmware Update Notification
About the HYBRID STANDBY indicator
Selecting the Language for the On-
screen Setup Menus
1st Step : Audyssey MultEQ: Auto Setup
2nd Step : Source Connection 
3rd Step : Remote Mode Setup
4th Step : Network Connection
Yes
No
Welcome to initial setup. Have you connected all the speakers and devices?
Before starting, please connect speakers and sources.
Now, would you like to start initial setup?
Exit
Initial Setup
HOME
1
Use 
q/w on the AV receiver or remote 
controller to select one of the following 
options, and then press ENTER.
`
Yes:
Continues to “Audyssey MultEQ: Auto 
Setup”.
`
No:
Skips the settings and terminates the initial 
setup. The setup wizard goes to 
“Terminating the Initial Setup” (
). 
You can always restart the initial setup by 
selecting “Initial Setup” in the “Hardware 
Setup” menu (
).
Audyssey MultEQ: Auto Setup
1
Use 
q/w to select one of the following options, 
and then press ENTER.
`
Do it Now: 
The automatic speaker setup is performed 
following instructions on screen. Refer to 
step 2 of “Using the Automatic Speaker 
Setup” (
). When this setting is 
complete, the setup wizard continues to 
“Source Connection”.
`
Do it Later: 
Skips this setting.
Press ENTER and continue to “Source 
Connection”.