ONKYO TX-NR626 Manuel D’Utilisation
Playback
En-45
Note
*1
(North American and Taiwanese models) This
listening mode is not available.
listening mode is not available.
*2
Pure Audio cannot be selected when Zone 2 is active.
Besides, if you activate Zone 2 while Pure Audio is
selected, the listening mode will automatically switch to
Direct.
Besides, if you activate Zone 2 while Pure Audio is
selected, the listening mode will automatically switch to
Direct.
*3
Based on the audio channel signal contained in the
source, the corresponding speakers will output the
sound.
source, the corresponding speakers will output the
sound.
*4
The AV receiver can input the DSD signal from HDMI IN.
Depending on the player, setting the output on the player
side to PCM might bring better sound.
Depending on the player, setting the output on the player
side to PCM might bring better sound.
*5
For the Blu-ray Discs, Dolby Digital is used in a 3.1/5.1-
channel speaker system.
channel speaker system.
*6
DTS is used depending on the configuration of the AV
receiver.
receiver.
*7
If there are no surround back speakers, DTS is used.
*8
If there are no surround back speakers, Dolby Pro Logic
II is used.
II is used.
You can display various information about the current
input source as follows.
input source as follows.
The following information can be typically displayed.
*1
When AM or FM radio is used, the band, preset number,
and frequency are displayed.
and frequency are displayed.
*2
If the input signal is digital, the signal format is displayed.
Information is displayed for about three seconds, then
the previously displayed information reappears.
Information is displayed for about three seconds, then
the previously displayed information reappears.
With the sleep timer, you can set the AV receiver to
turn off automatically after a specified period.
turn off automatically after a specified period.
The listening mode may not be selected depending
on the input signal. The signal input from the
external AV components can be displayed by the
function as follows.
on the input signal. The signal input from the
external AV components can be displayed by the
function as follows.
Displaying Source Information
1
Press RECEIVER once followed by DISPLAY
repeatedly to cycle through the available
information.
repeatedly to cycle through the available
information.
Tip
• Alternatively, you can use DISPLAY on the AV
receiver.
Sampling
frequency
Input source &
volume
Signal format
Listening mode
Input signal
resolution
Output resolution
Using the Sleep Timer
1
Press RECEIVER once followed by SLEEP
repeatedly to select the required sleep time.
The sleep time can be set from 90 to 10 minutes
in 10 minute steps.
The SLEEP indicator lights on the AV receiver’s
display when the sleep timer has been set. The
specified sleep time appears for about 5
seconds, then the previous display reappears.
repeatedly to select the required sleep time.
The sleep time can be set from 90 to 10 minutes
in 10 minute steps.
The SLEEP indicator lights on the AV receiver’s
display when the sleep timer has been set. The
specified sleep time appears for about 5
seconds, then the previous display reappears.
Tip
• If you need to cancel the sleep timer, press SLEEP
repeatedly until the SLEEP indicator goes off.
• To check the time remaining until the AV receiver
sleeps, press SLEEP. Note that if you press again on
SLEEP as the time being displayed is 10 minutes or
less, the sleep timer will go off.
SLEEP as the time being displayed is 10 minutes or
less, the sleep timer will go off.