Crown Audio CTS4200A Manuel D’Utilisation
page 35
CTs Power Amplifi ers
Operation Manual
3.4 Choose Input Wire
and Connectors
and Connectors
Figure 3.3 shows connector pin assignments for balanced wiring, and Figure
3.4 shows connector pin assignments for unbalanced wiring.
3.4 shows connector pin assignments for unbalanced wiring.
When possible, use balanced wiring for signal input, which provides better
rejection of unwanted noise and hum. For more information, refer to the Crown
Amplifi er Application Guide, available online at www.crownaudio.com
rejection of unwanted noise and hum. For more information, refer to the Crown
Amplifi er Application Guide, available online at www.crownaudio.com
NOTE: Custom wiring should only be performed by qualifi ed
per sonnel.
per sonnel.
Figure 3.3 Balanced Input
Connector Wiring
Figure 3.4 Unbalanced Input
Connector Wiring
3 Setup
3.5 Choose Output Wire and
Connectors
Connectors
Crown recommends using professionally constructed, high-
quality, two- or four-conductor, heavy gauge speaker wire and connectors. You
may use terminal forks or bare wire for your output connectors (see Fig ure
3.5). CTs amplifi er terminal strips accept up to 10 AWG terminal forks which fi t
over a #8 screw. For best results, Crown recommends Panduit part #PV10-
10LF-L or equivalent terminal fork. Screw spacing is shown in Figure 3.5.
quality, two- or four-conductor, heavy gauge speaker wire and connectors. You
may use terminal forks or bare wire for your output connectors (see Fig ure
3.5). CTs amplifi er terminal strips accept up to 10 AWG terminal forks which fi t
over a #8 screw. For best results, Crown recommends Panduit part #PV10-
10LF-L or equivalent terminal fork. Screw spacing is shown in Figure 3.5.
To connect outputs, fi rst remove the touch-proof cover plate covering the
ter minal strip by removing the screw which holds it in place.
ter minal strip by removing the screw which holds it in place.
To prevent the possibility of short-circuits, wrap or otherwise insulate exposed
loudspeaker cable and connectors. Also, a touch-proof cover plate, which
covers the terminal strips, is provided to help prevent short circuits. The cover
plate should be reinstalled after connecting outputs.
loudspeaker cable and connectors. Also, a touch-proof cover plate, which
covers the terminal strips, is provided to help prevent short circuits. The cover
plate should be reinstalled after connecting outputs.
Suggested below are guidelines to select the appropriate size of wire based on
the distance from amplifi er to speaker. Check with local code as this may vary.
the distance from amplifi er to speaker. Check with local code as this may vary.
Distance Wire Size
up to 25 ft (7.6 m)
16 AWG
26-40 ft (7.9-12.2 m)
14 AWG
41-60 ft (12.5-18.3 m)
12 AWG
Over 60 ft (18.3 m)
10 AWG
CAUTION: Never connect the speaker return to the chassis of the
amplifi er, or damage to the amplifi er may result.
amplifi er, or damage to the amplifi er may result.
CAUTION: Never use shielded cable for output wiring.
Figure 3.5 Output Connector Wiring
(Typical of two channels)
See the Crown Amplifi er
Appli cation Guide, available
online at www.crownaudio.com,
for pin assignments for
Appli cation Guide, available
online at www.crownaudio.com,
for pin assignments for
Output panel
shown with
touch-proof
cover plate
removed.
NOTE: CTs 8200 is shown. Some CTs 4200 features are in different locations.