Crown Audio CTS4200A Manuel D’Utilisation
page 37
CTs Power Amplifi ers
Operation Manual
3.6.3 Bridge-Mono 16/8 Mode
CAUTION: Never change the position of
the Mode Switch while the amplifi er
power is on. See Section 5.2.2 for more
information.
the Mode Switch while the amplifi er
power is on. See Section 5.2.2 for more
information.
Typical input and output wiring, along with level
control and Mode Switch settings are shown in
Figure 3.8. Make sure the Mode switch is set to
the “Bridge 16/8” position.
control and Mode Switch settings are shown in
Figure 3.8. Make sure the Mode switch is set to
the “Bridge 16/8” position.
INPUTS: Connect input wiring only to the lower-
(odd-) numbered channel pair.
(odd-) numbered channel pair.
OUTPUTS: Connect the speaker across the
posi tive terminals of each channel pair. Do not
use the negative terminals of the channel pair
when the pair is being operated in Bridge-Mono
mode.
posi tive terminals of each channel pair. Do not
use the negative terminals of the channel pair
when the pair is being operated in Bridge-Mono
mode.
NOTE: When operating the channel pair in
Bridge-Mono mode, turn down (full CCW) the
level control for the higher (even)-numbered
channel of the channel pair. The lower (odd)-
numbered level control works both channels.
Bridge-Mono mode, turn down (full CCW) the
level control for the higher (even)-numbered
channel of the channel pair. The lower (odd)-
numbered level control works both channels.
3.6.4 Bridge-Mono 100V Mode
CAUTION: Never change the position of
the Mode Switch while the amplifi er
power is on. See Section 5.2.2 for more
information.
the Mode Switch while the amplifi er
power is on. See Section 5.2.2 for more
information.
Typical input and output wiring, along with level
control and Mode Switch settings are shown in
Figure 3.9. Make sure the Mode switch is set to
the “Bridge 100V” position.
control and Mode Switch settings are shown in
Figure 3.9. Make sure the Mode switch is set to
the “Bridge 100V” position.
INPUTS: Connect input wiring only to the lower-
(odd-) numbered channel pair.
(odd-) numbered channel pair.
OUTPUTS: Connect the speaker across the
posi tive terminals of each channel pair. Do not
use the negative terminals of the channel pair
when the pair is being operated in Bridge-Mono
mode.
posi tive terminals of each channel pair. Do not
use the negative terminals of the channel pair
when the pair is being operated in Bridge-Mono
mode.
NOTE: When operating the channel pair in
Bridge-Mono mode, turn down (full CCW) the
level control for the higher (even)-numbered
channel of the channel pair. The lower (odd)-
numbered level control works both channels.
Bridge-Mono mode, turn down (full CCW) the
level control for the higher (even)-numbered
channel of the channel pair. The lower (odd)-
numbered level control works both channels.
3 Setup
Figure 3.8 System Wiring and Control Settings, Bridge-Mono Mode, 16/8 Ohm.
Figure 3.9 System Wiring and Control Settings, Bridge-Mono Mode, 100V
CH 4
DUAL
DUAL
BRIDGE
CH 3
CH 2
DUAL
DUAL
BRIDGE
CH 1
CH 4
DUAL
DUAL
BRIDGE
CH 3
CH 2
DUAL
DUAL
BRIDGE
CH 1
100V
See the Crown
Amplifi er Appli cation
Guide, available
online at www.
crownaudio.com, for
pin assignments for
commonly used
connector types.
Amplifi er Appli cation
Guide, available
online at www.
crownaudio.com, for
pin assignments for
commonly used
connector types.