Earthquake Sound P10 Manuel D’Utilisation

terminals will accept up to 16-gauge quality speaker 

Connect with RCA type patch cords to the line level 

wire. The Inputs should be connected to the left and 

output of your receiver or pre-amp. If your pre-

right speaker terminals of your amplifier or receiver. 

amplifier or receiver has a single sub/LFE output, 

The Outputs should run from the subwoofer to the left 

connect it to the subwoofer's left input jack. There is 

and right satellite speakers. Remember: Always 

no need to use the subwoofers right input jack. If you 

connect red-to-red and black-to-black, when making 

want to run your main/satellite speakers full range, 

connections between an amplifier/receiver to the 

use a "Y" adapter at the pre-amplifier outputs. In this 

subwoofer. If you inadvertently reverse one of the 

way, you can send the pre-amplifier's output signal to 

connections (i.e., red-to-black), you will notice a lack 

your main amplifier and to the subwoofer at the same 

of bass from your subwoofer.

time.

(2) High Level Inputs / Outputs
Under normal conditions, the preferred connection is 
through the Line Level inputs. If this is difficult or not 
possible in your system, then you can use the 
Speaker Level inputs. Also, if you experience 
excessive noise or hum with the Line Level input, 
often a simple change to the Speaker Level input will 
result in a lower background noise level.

Connect the Speaker Level inputs to the speaker-level 

In the “ON” position, the subwoofer will remain “on” 

outputs of your amplifier or receiver using speaker 

constantly or can turn “on” and “off” automatically 

wire. The binding posts can accept bare wire 

when the “AUTO/ON” circuit is engaged. In the “OFF” 

connections only.

position, the subwoofer will remain off until the switch 
is manually turned back to the “ON” position.

High Level: Connecting the Subwoofer using the high 
level speaker connections: On the rear of your MiniMe 

Subwoofer are two pairs of red and black binding 

The subwoofer is supplied with a conservative, slow-

posts. One set is marked “Input” and one set is 

blow type fuse to protect the electronics.

marked “Output”, with each pair designated as left or 
right. Each post is color-coded black/red. These 

The voltage switch is positioned according to area 
voltage requirements. It has been pre-set
prior to shipping from the factory.
CAUTION
Do not try to alter the voltage setting, as doing so will 
result in a blown fuse. A wrong setting
may result in damaged electronics.

Control Panel Overview

Overview Continued On Next Page»

(5) Line Fuse

(9) 0-180° Phase Shift 

(11) 50Hz - 160Hz
Frequency Adjustment 

(12) Volume Control 

(10) Sub Operation Switch

(8) Power Status LED

(1) 
     Inputs and Outputs

Line Level RCA

(7) Auto ON/OFF

(2) Speaker
     Inputs and Outputs

 Level

(4) Manual ON/OFF Switch

(3) Voltage Selection Switch

(6) 110-120V AC Power Connection 

WARNING

600 WATTS

POWERED

SUBWOOFER

FUSE