Earthquake Sound P10 Manuel D’Utilisation

When the main “POWER” ON/OFF switch is in the 

In LFE position, the Frequency adjustment becomes 

“OFF” position, this switch has no affect on the 

disabled and the subwoofer runs in a Full range 

subwoofer. When the main “POWER ON/OFF” switch 

mode, from 20Hz - 2kHz. 

is in the “ON” position, this switch allows the auto 
circuit to be engaged. When this switch is in the 

While in Sub position the subwoofer reverts to the 

“AUTO” position, the subwoofer will automatically turn 

manual frequency adjustment, allowing the user to 

“on” when it senses a signal. It will automatically turn 

operate and fine tune the subwoofer to their personal 

“off” after 20 minutes with no signal. When this switch 

taste.

is in the “ON” position, the subwoofer will remain on 
as long as the “POWER” ON/OFF switch is in the 

“ON” position.

This controls the high frequency cutoff point. With the 
control set to the middle, the subwoofer will reproduce 

(7) 110-120V AC Power Connection 

frequencies up to 105Hz. If the control is set fully 

The Earthquake MiniMe is equipped with a built in 

clockwise, the crossover is bypassed and the 

standard, two-prong power connection.

subwoofer will reproduce a wide frequency range. 
With the control fully counter-closkcwise the 

subwoofer reproduces a narrow range, up to 50Hz.

Earthquake powered subwoofers have an LED on the 
panel that indicates the status of the built-in amplifier. 

Rotate the control until the bass sound natural. If the 

The LED will light red when the amplifier is in standby 

mid-bass sounds natural but you want more low bass, 

mode and green when the amplifier is on and 

turn the control down a little.

receiving a signal.

Manual volume control to regulate your subwoofers 

This control is used to acoustically match the 

power output, to prevent clipping and distortions 

subwoofer’s output to your main speakers. Select the 

caused by overpowering.

position, either 0° or 180°, in which your subwoofer 
has more output at the listening position.

 

inspecting or changing the fuse. Never 
use a fuse with a larger current rating 
than recommended.

Always unplug the power cord before

Control Panel Overview Continued