ONKYO HT-RC260 Manuel D’Utilisation

En

`

COAX:

This can be selected when COAXIAL IN has been 
assigned as an input source. If both coaxial and opti-
cal inputs have been assigned, coaxial input is auto-
matically selected as a priority.

`

OPT:

This can be selected when OPTICAL IN has been 
assigned as an input source. If both coaxial and opti-
cal inputs have been assigned, optical input is auto-
matically selected as a priority.

`

Analog:

The AV receiver always outputs analog signals.

• The setting is stored individually for each input selector.
• This setting can be made only for the input source that is 

assigned as HDMI IN, COAXIAL IN, or OPTICAL IN.

*1

You can select “ARC” if you select the TV/CD input selector. 
But you cannot select it if you’ve selected “Off” in the “Audio 
Return Channel” setting (

By pressing ENTER while selecting “HDMI”, “COAX”, 
“OPT” in the “Audio Selector”, you can specify the input 
signal in the Fixed Mode. Pressing ENTER again allows 
you to return to the “Audio Selector” setting.
Normally, the AV receiver detects the signal format auto-
matically. However, if you experience either of the follow-
ing issues when playing PCM or DTS material, you can 
manually set the signal format to PCM or DTS.
• If the beginnings of tracks from a PCM source are cut 

off, try setting the format to PCM.

• If noise is produced when fast forwarding or reversing a 

DTS CD, try setting the format to DTS.

`

Auto: 

The format is detected automatically. If no digital 
input signal is present, the corresponding analog 
input is used instead.

`

PCM:

Only 2-channel PCM format input signals will be 
heard. If the input signal is not PCM, the PCM indi-
cator will flash and noise may also be produced.

`

DTS:

Only DTS (but not DTS-HD) format input signals 
will be heard. If the input signal is not DTS, the DTS 
indicator will flash and there will be no sound.

• The setting is stored individually for each input selector.
• The setting will be reset to “Auto” when you change the setting 

in the “Audio Selector” (

46).

You can adjust the bass and treble for the front speakers, 
except when the Direct listening mode is selected.

■

■

See “Bass” and “Treble” in “Tone Control Settings” 
(

45).

• To bypass the bass and treble tone circuits, select the Direct lis-

tening mode.

• Alternatively, you can use the remote controller’s AUDIO and 

arrow buttons (

1

2