Echo SRM-410U Manuel D’Utilisation

When engine is started, confi rm that there is not any abnormal 
vibration or  sound.   If there is abnormal vibration or sound, ask 
your DEALER to repair. After refueling tighten fuel cap fi rmly and 
check for leakage. In case of fuel leakage repair before starting 
operation since there is a danger of fi re.

Th

  e attachment will operate immediately when the engine starts, 

and could result in possible serious injury.  Keep movable parts of 
the attachment away from objects that could become entangled or 
thrown, and surfaces that could cause loss of control.

1. Stop Switch

Move stop switch (A) forward away from the STOP position.

2. Choke

Move choke lever (B) to Cold Start Position  (

).

3. Purge Bulb

     Pump purge bulb (C) until fuel is visible and fl ows freely in the 

clear fuel tank return line. Pump bulb an additional 4 or 5 times.

4.  Press the decompression device (E).

5. Recoil Starter

Lay the unit on a fl at area and keep movable attachment parts clear 
of all obstacles. Hold unit fi rmly, and rapidly pull recoil starter 
handle/rope (D) until engine fi res (or maximum fi ve [5] pulls).

6. Choke
 After 

engine 

fi res (or 5 pulls), move choke lever back to Run 

 (

) position.  Pull recoil starter starter handle/rope until engine 

starts and runs. Allow unit to warm up at idle for several minutes.

NOTE
If engine does not start with choke in “Run” position after 5 pulls, 
repeat instructions 2 - 5.

7. Throttle Trigger
 

After engine warm-up, gradually depress throttle trigger to increase 
engine RPM to operating speed.