Scag Power Equipment SWZV Manuel D’Utilisation

C. 4" Position (factory setting) - (See Figure 6-9, Page

26).
Placing the baffle in the 4" setting will enhance fall
cutting (leaf pickup).

A. 3" Position -  (See Figure 6-9, Page 26).

For very tall, wiry, tough to cut grass.

B. 3-1/2" Position - (See Figure 6-9, Pagee 26).

For general purpose cutting. Placing the Custom-Cut
Baffle in the 3-1/2" position gives a good mix of
cutting performance in all types of grass.

A. 3-1/2" or 3-3/4" Position - (See Figure 6-10, Page 26).

For very tall, wiry or tough-to-cut grass.

B. 4" (factory setting), 4-1/4" or 4-1/2" Position - (See

Figure 6-10, Page 26).
For general purpose cutting.  This gives the best mix
of cutting performance in all types of grass.

C. 4-3/4" or 5-1/4" Position - (See Figure 6-10, Page 26).

Placing the baffle in either the 4-3/4" or 5-1/4" setting
will enhance fall cutting (leaf pickup) and reduce
cutter deck "blowout".

To adjust the Custom-Cut Baffle height:

1. Place the cutter deck in the transport position.

2. Remove the hardware securing the Custom-Cut

Baffle to the cutter deck.

3. Move the Custom-Cut Baffle to desired position.

(See Figures 6-9, Page 26).

4. Reinstall the mounting hardware.  Torque hardware

to 39 ft-lbs

To adjust the Custom-Cut Baffle height:

1. Place the cutter deck in the transport position.

2. Remove the hardware securing the Custom-Cut

Baffle to the cutter deck.

3. Move the Custom-Cut Baffle to desired position.

(See Figures 6-10, Page 29).

4. Reinstall the mounting hardware.  Torque hardware

to 39 ft-lbs