Scag Power Equipment SWZU Manuel D’Utilisation

To Adjust the Custom-Cut Baffle height:

Hardware location used in the illustrations are for
reference only. Location of hardware may vary
depending on the cutter deck size.

-NOTE-

Figure 7. 3-1/2" Custom-Cut Baffle Position

Figure 8. 4" Custom-Cut Baffle Position

NEUTRAL ADJUSTMENT

-NOTE-

Neutral has been set by your Scag dealer at the
time of setup and normally does not need to be
adjusted. If, however, you find that neutral has
come out of adjustment, follow the procedure
below.

1. Raise the drive wheels off the ground and block the

caster wheels to prevent the machine from moving.

2. Make sure the speed control lever is in neutral, the

steering control levers are in the neutral latch
position, and the parking brake is on. Start the
engine.

3. Release the parking brake and note if the tires are

rotating.

C. 4" Position - baffle is installed using the bottom set of

holes on the front baffle welded inside the cutter
deck. (See Figure 8). Placing the baffle in the 4"
setting will enhance fall cutting (leaf pickup) and
reduce cutter deck "blowout".

1. Remove the hardware securing the Custom-Cut Baffle

to the cutter deck (See Figure 5).

Figure 5. Custom-Cut Baffle

2. Move the Custom-Cut Baffle to desired position. (See

Figures 6 through 8 for position).

3. Reinstall the mounting hardware as shown. (See Figures

6 though 8). Torque hardware to 39ft.lbs.

Figure 6. 3" Custom-Cut Baffle Position

2004 CCB

MOUNTING
HARDWARE

TOP SET OF HOLES
FOR 3" SETTING

2004 CCB - 3" Setting

CARRIAGE BOLT

ELASTIC STOP
NUT

MIDDLE SET OF HOLES
FOR 3-1/2" SETTING

2004 CCB - 3-1/2" Setting

CARRIAGE BOLT

ELASTIC STOP
NUT

BOTTOM SET OF HOLES
FOR 4" SETTING

2004 CCB - 4" Setting

CARRIAGE BOLT

ELASTIC STOP
NUT