Scag Power Equipment SWZU Manuel D’Utilisation

1. Adjust the parking brake so that when the brake

hand lever is against the stop on the handle bar, the
brake levers on the brake shaft weldment are
against the stops on the engine deck.

2. Adjust the brake actuator rod on either side of the

machine to obtain proper brake adjustment.

3. If the machine pulls to one side. Stop the mower by

placing the steering control levers in the neutral
position. Using the adjustment wrench located on the
left side of the machine, turn the tracking adjustment
nut on the slower side counter clockwise until the
machine tracks straight. (See Figure 11)

4. Bring the steering control levers back to the neutral

lock position and check to see that the machine does
not creep forward on the adjusted wheel.

5. If the machine creeps in neutral you have moved out

of the neutral band and will have to turn the tracking
adjustment nut clockwise until the machine does not
creep.

6. Repeat steps 1 and 2. If the machine continues to

pull to one side, stop the mower by placing the
steering control levers in the neutral position. Turn
the tracking adjustment nut on the faster side clock-
wise until the machine tracks straight.

7. If tracking cannot be achieved, contact your Scag

servicing dealer.