Troy-Bilt Colt RZT Manuel D’Utilisation

Deck Height Index
Deck Lift Handle
RH and LH Drive Control Levers
Ignition Switch
PTO Switch
Transmission Bypass Rod (Not Shown)
Cup Holder

A.
B.
C.
D.
E.
F.
G.

Storage Tray
Seat Adjustment Lever (Not Visible)
Fuel Tank Cap
Hour Meter/Indicator Panel
Throttle Control
Parking Brake Engagement Lever

H.
J.
K.
L.
M.
N.

NOTE: References to LEFT, RIGHT, FRONT, and REAR indicate 
that position on the tractor when facing forward while seated 
in the operator’s seat. 

The deck height index consists of six index notches 
located on the front/right of the seat box frame. Each 
notch corresponds to a 1/2 inch change in the deck height 
position ranging from 1-1/2 inches at the lowest  notch to 4 
inches at the highest notch.

The deck lift handle is located on the front/right of the seat 
box frame, and is used to raise and lower the mower deck.

Pull the handle to the left out of the index notch and push 
downward to lower the deck, or pull upward to raise the 
deck. When the desired height is attained, move the lift 
handle to the right until fully in the index notch.

The RH and LH control levers are located on each side of 
the operator’s seat. These hinged levers pivot outward 
to open space to permit the operator to either  sit in the 
tractor seat, or to dismount the tractor. The levers must be 
fully opened out and in the neutral position to start the 
tractor engine.

A

B

C

D

E

F

G

H

K

L

M

C

F

N

J