Husqvarna 15Ts AWD Manuel D’Utilisation

English

 – 19

Clean the machine directly after use. It is much easier to wash 
off grass cuttings before they dry.

Oily dirt can be removed using a cold degreasing agent. 
Spray on a thin layer.

Rinse at normal water pressure.

Do not direct the jet towards electrical components or 
bearings.

Do not rinse hot surfaces such as the engine and exhaust 
system.

It is recommended that you start the engine and run the 
mower for a short period after cleaning, so that any remaining 
water is blown off.

Lubricate the machine if necessary after cleaning. Carry out 
extra lubrication when the bearings have been exposed to a 
degreaser or a water jet.

The engine becomes accessible for service when the engine 
cover is opened.

Fold the seat forward, loosen the snap lock under the seat 
and fold the cover backwards.

Release the clip on the front hood and lift off the fender.

Remove the accelerator knob (1), screws (2 and 3), and 
remove the cover.

Remove the screws holding the wing cover (2) and lift off the 
cover.

The steering is controlled by means of wires.

These can in time become slack, which implies that the 
adjustment of the steering becomes altered.

Check and adjust the steering as follows:

1

Remove the frame plate by loosening the screws (2) and 
lift the frame plate by the rear edge.

Avoid using a high pressure washer or a steam cleaner. 
There is a major risk of water penetrating into bearings and 
electrical connections. Corrosion attack can result, which 
will lead to running problems. Cleaning additives generally 
aggravate the damage.