Husqvarna 15Ts AWD Manuel D’Utilisation

20 – 

English

2

Check the tension of the steering wires by squeezing 
them together by the arrows as illustrated. It should be 
possible to push them together so that the distance 
between them is half as much, without using unnecessary 
force.

3

If necessary, the wires can be adjusted by tightening the 
adjuster nuts on each side of the steering collar. Do not 
over tighten the cables; they should only be drawn in 
towards the steering collar.

Hold the cable, for example using an adjustable wrench, 
so that it does not twist.

If the adjustment is only made on one side, the middle 
position of the steering will be affected.

Check the wire tension on completion of the adjustment 
as per item 2.

The parking brake is adjusted as follows:

1

Loosen the locking nuts (1).

2

Tension the cable using the adjuster screw (2) until the 
play in the cable is taken up.

3

Tighten the locking nuts (1) after adjustment.

4

The parking brake should be checked again after the 
adjustment has been made.

Check that the parking brake is adjusted correctly by placing 
the machine on a slope with the front and rear axles 
disengaged.

Apply and lock the parking brake. When the machine does not 
stand still, the parking brake should be adjusted according to 
the following.

1

Remove the left-hand wing cover.

2

Loosen the locking nuts (1).

3

Tension the cable using the adjuster screw (2) until the 
play in the cable is taken up.

4

Tighten the locking nuts (1).

5

The brake should be checked again after adjustment

6

Assemble the left-hand wing cover.

Check that the engine responds to the throttle control and that 
the correct engine speed is achieved at full throttle.

If doubts arise, contact your service representative.

If adjustment is necessary, adjust the lower wire as follows:

1

Loosen the clamping screw for the cable’s outer casing 
and move the throttle to the full throttle position.

2

Check that the throttle wire is attached to the correct hole 
in the lower lever, see diagram.

3

Pull the throttle wire casing to the far left and tighten the 
clamping screw.