Cal Spas LTR20091002 Manuel D’Utilisation
2009 Inground Spas
LTR20091002, Rev. B
Operating
Your Spa
www.calspas.com
19
Your new Cal Spa comes equipped with an electric heater. Following the directions listed below will ensure
the most efficient operation:
NOTE: This method is only for spa usage under two hours a week.
NOTE: This method is only for spa usage under two hours a week.
Keep the spa’s operating temperature 5˚ F below the desired usage temperature when not in use. One
•
or two hours before use, set the temperature to the desired temperature.
If the spa usage exceeds two hours a week, the set temperature should remain at the desired usage
If the spa usage exceeds two hours a week, the set temperature should remain at the desired usage
•
temperature.
The air venturis should be used sparingly. When open, water temperature drops quite rapidly and can
The air venturis should be used sparingly. When open, water temperature drops quite rapidly and can
•
also dissipate chemicals.
Allowing the water temperature to lower more than 10˚F below the desired usage temperature and reheating
it prior to usage will cause the heater to operate longer than it normally would maintaining the desired tem-
perature. Doing this will increase your operating cost and makes your heater work more than necessary.
Periodic Reminder Messages
Press the “Mode” button to reset a displayed reminder.
Message
Frequency
Action Required
rPH
Every 7 days
Test and adjust chemical levels per manufacturer’s instructions.
rSA
Every 7 days
Test and adjust chemical levels per manufacturer’s instructions.
rCL
Every 30 days
Remove, clean, and reinstall filter per manufacturer’s instructions.
rtg
Every 30 days
Test and reset GFCI per manufacturer’s instructions. Drain and refill
spa per manufacturer’s instructions.
rdr
Every 90 days
Drain and refill spa per manufacturer’s instructions.
rCO
Every 180 days
Clean and condition spa cover
rCH
Every 365 days
Install New Bio-Clean™ Filter