Cal Spas 6200 Manuel D’Utilisation
2008 Portable Spa Owner’s Manual
Page 9
LTR20081000, Rev. B
Preparing for Your New Portable Spa
Filling and Powering Up Your Portable Spa
Never fill your spa with soft water. Soft water makes it
impossible to maintain the proper water chemistry and
may cause the water to foam, which will ultimately harm
impossible to maintain the proper water chemistry and
may cause the water to foam, which will ultimately harm
the finish of the spa and void your warranty.
Once the spa has been placed on an approved
surface and has been correctly wired by a licensed
electrician, inspect all plumbing connections in the
equipment area of your spa. Ensure that these
connections are secure and that they did not loosen
during shipment.
surface and has been correctly wired by a licensed
electrician, inspect all plumbing connections in the
equipment area of your spa. Ensure that these
connections are secure and that they did not loosen
during shipment.
If equipped, open all gate valves in the equipment
area. Before operating the spa, these valves must
be in the up or “open” position.
area. Before operating the spa, these valves must
be in the up or “open” position.
Remove the filter basket and cartridge from skimmer/
filter canister.
Place a garden hose in the skimmer/filter canister
Place a garden hose in the skimmer/filter canister
and fill your spa with regular tap water to the proper
water level (halfway up the skimmer area).
water level (halfway up the skimmer area).
(For owners of the automatic bromine generator)
Make sure the dial on the face of the bromine
generator unit is turned to the OFF position.
Make sure the dial on the face of the bromine
generator unit is turned to the OFF position.
Open the air relief valve (located next to the two
filters, if equipped) after the air bubbles stop coming
out of it. Close the valve hand-tight.
out of it. Close the valve hand-tight.
1.
2.
3.
4.
5.
6.
Once the water is at the correct level and air is bled,
turn on the power at the GFCI breaker. (Ensure that
the 120V spas are connected to the proper electrical
outlet.)
turn on the power at the GFCI breaker. (Ensure that
the 120V spas are connected to the proper electrical
outlet.)
Note: Depending on the model, when the power
is turned on to the spa, the controls will perform a
is turned on to the spa, the controls will perform a
diagnostic check for approximately five minutes. When
the diagnostic is complete, the spa will automatically
the diagnostic is complete, the spa will automatically
operate at filter speed and continue heating until the spa
water temperature reaches the default temperature of
water temperature reaches the default temperature of
100˚F.
If no water is flowing when the pump is running
there could be an air pocket at the suction side of
the pump. Shut off power to the spa and loosen the
pump union on the suction side of the pump to bleed
the air. When air is bled, turn power back on.
there could be an air pocket at the suction side of
the pump. Shut off power to the spa and loosen the
pump union on the suction side of the pump to bleed
the air. When air is bled, turn power back on.
Re-install the filter and the filter basket into the
skimmer/filter canister.
The spa is now ready for use.
NOTE: Never run the spa with the gate valves closed
or without water circulating for long periods of time. Be
or without water circulating for long periods of time. Be
careful not to over-tighten the plumbing fittings.
7.
8.
9.