Country Home Products A2105BEA Manuel D’Utilisation

Step 5: Rotation Handle Installation  
(Figure 5) 

1.  On the left side handlebar of the DR

®

 ALL-

™

 MOWER, install the rotation 

handle support (item 1) at approximately 28" 
from the ground, using the U-bolt (item 2), 
plate and nuts. 

2.  Insert the plastic bushing (item 3, flange 

facing the operator) on the housing by 
pushing forward until it snaps. 

3.  Insert the worm shaft (item 4) in the plastic 

bushing. 

4.  Place the flat washer (item 5) and lock the 

shaft in place with the cotter pin (item 6). 

5.  Insert the plastic bushing (item 3, flange 

facing the operator) into the rotation handle 
support (item 1). 

6.  Insert the rotation handle (item 7) through 

the support then in the worm shaft (item 4). 
Secure with the hairpin (item 8). 

7.  Operate the handle and check for proper 

operation of the chute. 

 

 WARNING: 

Make sure the chute blocks 

in both directions to prevent the snow from 
being projected in the operator's area 
(Figure 6).