Numark Industries CM-100 Manuel D’Utilisation

©1999 

 Industries

- 10 -

http://www.numark.com

27

28

29

30

31

33

36

32

35 34

38

37

39

40

27.  Phono Inputs – for attaching your turntables. When

these connectors are used, your  signal is fed directly to the
high-quality RIAA phono pre-amplifiers.     

Use this

position only for turntables   . Line level sources will
overload the sensitive phono pre-amps and will cause
distortion.

28.  Grounding lug - for turntable connection.  Always use

this connection when using turntables. (your turntable
cable should have a grounding wire)

29.  Line/Phono Input switch - to allow line level

equipment to be plugged into your phono inputs giving
you a total of 8 line input options.

30.  Line Inputs – are unbalanced RCA jacks for

connecting stereo audio from line level sources such as
CD players, HiFi VCRs, cassette and reel-to-reel tape
decks, DAT machines, laser discs, tuners, even
synthesizers or other mixing consoles.

31.  Mic Input – for your 1/4” Microphone plug.

32.  Cue/Send Output – to temporarily send channel PFL

signal to an external sampler or other source such as both
monitor.  Your PFL cue buttons selects the source.

33.  Record Outputs – are unbalanced RCA jacks used to

send the output of the program to any connected recording
device.

34.  Stereo Zone Outputs – are unbalanced RCA jacks

controlled by the Booth/Zone Level control.

35.  Stereo Main Outputs – are unbalanced RCA

connectors controlled by the Master fader.

36.  Stereo Balanced Main Outputs – are low-impedance

XLR type connectors controlled by the Master fader.

37.  Fader Start Connector – to attach your mixer to a

remote start equipped Numark CD player using industry
standard 1/8”(3.5mm) cables.

38.  Equalizer Deactivation Switch – to turn off the EQ

control and avoid accidental usage.

39.  IEC Power Connector – to plug in your power cord.

40.  Voltage Selector – to set to your country’s standard.