Справочник Пользователя для Numark Industries CM-100
CM100
- The Leader in DJ Technology
©1999
Industries
- 10 -
http://www.numark.com
REAR PANEL FEATURES
27
28
29
30
31
33
36
32
35 34
38
37
39
40
27. Phono Inputs – for attaching your turntables. When
these connectors are used, your signal is fed directly to the
high-quality RIAA phono pre-amplifiers.
high-quality RIAA phono pre-amplifiers.
Use this
position only for turntables . Line level sources will
overload the sensitive phono pre-amps and will cause
distortion.
overload the sensitive phono pre-amps and will cause
distortion.
28. Grounding lug - for turntable connection. Always use
this connection when using turntables. (your turntable
cable should have a grounding wire)
cable should have a grounding wire)
29. Line/Phono Input switch - to allow line level
equipment to be plugged into your phono inputs giving
you a total of 8 line input options.
you a total of 8 line input options.
30. Line Inputs – are unbalanced RCA jacks for
connecting stereo audio from line level sources such as
CD players, HiFi VCRs, cassette and reel-to-reel tape
decks, DAT machines, laser discs, tuners, even
synthesizers or other mixing consoles.
CD players, HiFi VCRs, cassette and reel-to-reel tape
decks, DAT machines, laser discs, tuners, even
synthesizers or other mixing consoles.
NOTE: Plug mono audio sources into both Left and
Right inputs using a "Y" cable connector.
Right inputs using a "Y" cable connector.
31. Mic Input – for your 1/4” Microphone plug.
32. Cue/Send Output – to temporarily send channel PFL
signal to an external sampler or other source such as both
monitor. Your PFL cue buttons selects the source.
monitor. Your PFL cue buttons selects the source.
33. Record Outputs – are unbalanced RCA jacks used to
send the output of the program to any connected recording
device.
device.
34. Stereo Zone Outputs – are unbalanced RCA jacks
controlled by the Booth/Zone Level control.
35. Stereo Main Outputs – are unbalanced RCA
connectors controlled by the Master fader.
36. Stereo Balanced Main Outputs – are low-impedance
XLR type connectors controlled by the Master fader.
37. Fader Start Connector – to attach your mixer to a
remote start equipped Numark CD player using industry
standard 1/8”(3.5mm) cables.
standard 1/8”(3.5mm) cables.
38. Equalizer Deactivation Switch – to turn off the EQ
control and avoid accidental usage.
39. IEC Power Connector – to plug in your power cord.
40. Voltage Selector – to set to your country’s standard.